changed crankshaft position sensor now vacuum cleaner whine when engine is running
12-16-2014, 09:41 AM
#1
New Member
Thread Starter
Join Date: 11-09-14
Location: savannah, Ga
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
changed crankshaft position sensor now vacuum cleaner whine when engine is running
So I took my intake manifold off and changed my crank sensor, put everything back and now my car has a terrible whine when car is running. It stops when I give it gas...did a boost leak test before I started which was fine. Did it again after and it blows air through the oil cap now. I drove it about 5 miles down the road and when I let off the gas it backfires like crazy....any thoughts??
12-19-2014, 04:28 AM
#4
Senior Member
So I took my intake manifold off and changed my crank sensor, put everything back and now my car has a terrible whine when car is running. It stops when I give it gas...did a boost leak test before I started which was fine. Did it again after and it blows air through the oil cap now. I drove it about 5 miles down the road and when I let off the gas it backfires like crazy....any thoughts??
Last edited by LNFwagonSS; 12-19-2014 at 04:28 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
twilson380
2.0L LNF Performance Tech
6
09-14-2015 10:52 AM
Getaway_Driver
08-10 SS Turbocharged General Discussion
40
09-10-2015 09:11 AM
Getaway_Driver
Problems/Service/Maintenance
41
09-08-2015 09:41 AM