GM 2.2 Ecotec Limits and Upgrades
#1
New Member
Thread Starter
Join Date: 04-30-07
Location: Chicago
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
GM 2.2 Ecotec Limits and Upgrades
GM 2.2 Ecotec Limits and Upgrades, based on info from GM's Sport Compact Performance Build Book.
Last edited by OldPro; 05-21-2007 at 04:53 PM. Reason: Better chart image!
#6
Premium Member
Wop
#7
Senior Member
Join Date: 07-15-06
Location: Pocomoke City, MD
Posts: 3,765
Likes: 0
Received 0 Likes
on
0 Posts
actually. the build guide does referance Wiseco pistons, egale rods, ferrea valves and springs, and the bates valves and springs. there is an updated/edited build guide out that has these parts in there. the alpine isnt listed in it, they recomend Hahns ecotec turbo with fuel managment system. and you can get all of the engine components are turbotechracing.com which is a supporting vendor. also where i bought all my engine internals.
#8
Senior Member
Join Date: 10-21-06
Location: Twin Cities, MN
Posts: 864
Likes: 0
Received 0 Likes
on
0 Posts
related to the post... where did u get that 2.5" is good to 300hp and no higher? just curious.
#10
New Member
Join Date: 11-12-14
Location: san antonio tx
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
I'm new to this I bought a cobalt from Marty ladwig he's a two time national champion fwd class anyway the car has only 15 miles on it a full roll cage and a new 2.2l installed but not wired (all electronics were stripped) Fuel cell in the trunk exc my question is I have no electronics with the turbo kit I have and I'm wondering if there's a one stop device to manage all aspect's of adding a turbo to a non-turbo car?
#12
Senior Member
Stock Pistons wont hold over 250hp long. There just too weak and a bad pull will end them easy.
I've ran a stock motor with a intake and exhaust with a 100 wet kit no problems
I've ran a stock motor with a intake and exhaust with a 100 wet kit no problems
#13
New Member
Join Date: 08-06-16
Location: East Valley, AZ
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
originally posted by aikidoshadow on **************/phpbb3
reposted by ionit3 on **********************************/threads/gm-ecotec-build-books-with-links.182/
Cam Shaft info
http://www.sixthsphere.com/storage2/...hiaex1dyq3.pdf
Racing Build Book
http://www.sixthsphere.com/storage2/...xs2cru3p4y.pdf
Sport Compact buildbook
http://www.sixthsphere.com/storage2/...34ogo32ore.pdf
Block Print
http://www.sixthsphere.com/storage2/...vdertzjo9w.pdf
Manual bolt pattern
http://www.sixthsphere.com/storage2/...lknlzzgyk6.pdf
reposted by ionit3 on **********************************/threads/gm-ecotec-build-books-with-links.182/
Cam Shaft info
http://www.sixthsphere.com/storage2/...hiaex1dyq3.pdf
Racing Build Book
http://www.sixthsphere.com/storage2/...xs2cru3p4y.pdf
Sport Compact buildbook
http://www.sixthsphere.com/storage2/...34ogo32ore.pdf
Block Print
http://www.sixthsphere.com/storage2/...vdertzjo9w.pdf
Manual bolt pattern
http://www.sixthsphere.com/storage2/...lknlzzgyk6.pdf
Thread
Thread Starter
Forum
Replies
Last Post