SC 2.2 bent valves/build
#26
Senior Member
Thread Starter
I don't think I want to modify the head to make supertechs work,but I will let you know if I change my mind.I appreciate the offer though
yeah yours is identical to mine.I'm about 99.99999% positive that his is a VVT head.
yeah yours is identical to mine.I'm about 99.99999% positive that his is a VVT head.
Last edited by 1LowLS; 05-29-2012 at 01:22 PM. Reason: Automerged Doublepost
#37
Senior Member
I still kick myself for selling my rods 3 years ago. My now wife was hounding me to get the car running so i sold them to get a stock block. Damn women. Cant wait to see what you can do on the m62.
#38
Senior Member
Thread Starter
I excited to get her running again.I ordered a asston of stuff last night so as soon as those parts show up I'll start putting her back together.
#39
Senior Member
I know the feeling lol all too well. I need a retune or a real hpt tune, after i put my new motor in i cant get over 5psi without the ****** leaning out. Gay driving around on 5psi.
#44
Senior Member
Thread Starter
ZZP 82# springs and retainers.Thanx to CED for the cam gear bolts and balancer bolt.pistons and rings are put together.waiting for rod bearings and head studs to arrive along with valves.
Last edited by 1LowLS; 06-24-2012 at 04:39 AM.
#46
Senior Member
Thread Starter
Got stuff delivered today.Halfway done with head assembly.intake side is ported,valves installed.Exhaust side I stopped after porting 2 cuz it got to 130* in my garage lol.rod bearings come tomorrow then I can work on full assembly.
Last edited by 1LowLS; 06-24-2012 at 04:41 AM.
#49
Senior Member
Thread Starter
Worked on the motor for a bit.fkn hot out!!
This is my factory rod bearing with 107,000 miles on it being beaten for most of its life.Thank you Castrol Syntec Edge for being a sickass,badass uber dope oil!Castrol customer for life after seeing this.
Springs and intake valves in.Exhaust valves are being cleaned.
Got 2 pistons out but stopped cause a heat wave formed inside my garage lol.More to come.
This is my factory rod bearing with 107,000 miles on it being beaten for most of its life.Thank you Castrol Syntec Edge for being a sickass,badass uber dope oil!Castrol customer for life after seeing this.
Springs and intake valves in.Exhaust valves are being cleaned.
Got 2 pistons out but stopped cause a heat wave formed inside my garage lol.More to come.