Bent Radiator Support
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: 03-25-09
Location: Plattsburgh, NY
Posts: 904
Likes: 0
Received 0 Likes
on
0 Posts
Bent Radiator Support
When my motor blew in my car I had to tow it with a truck. The kid that towed me bent the **** out of my Radiator support. It is bent 4in to the left from the gm performance badge under the hood.
This is not a serviceable part. Someone on here has had to run into this problem before. How did you fix it. Not so nice to look at now.
This is not a serviceable part. Someone on here has had to run into this problem before. How did you fix it. Not so nice to look at now.
#4
you towed from under the hood?
I got pulled out of sand in my mustang 10ish years ago, lower rad support bent. I couldnt straighten it. On the cobalt, it is a welded on peice that can be replaced for a large bill. I can look it up if you really need. It is a body shop repair.
I got pulled out of sand in my mustang 10ish years ago, lower rad support bent. I couldnt straighten it. On the cobalt, it is a welded on peice that can be replaced for a large bill. I can look it up if you really need. It is a body shop repair.
#6
Senior Member
iTrader: (1)
Join Date: 09-29-05
Location: Austin, TX
Posts: 1,083
Likes: 0
Received 0 Likes
on
0 Posts
You can replace the upper core support but you have to drill out the spot welds and re-weld it. I think you also have to check the alignment of the frame when you do this.
Fun stuff.
Fun stuff.
#7
I'm too JDM for you
iTrader: (7)
COBALT G5 RADIATOR SUPPORT TIE BAR UPPER PRIMERED STEEL | eBay
the good part is that the part is cheap, getting it installed? probably not
the good part is that the part is cheap, getting it installed? probably not
#8
Senior Member
Thread Starter
iTrader: (1)
Join Date: 03-25-09
Location: Plattsburgh, NY
Posts: 904
Likes: 0
Received 0 Likes
on
0 Posts
you towed from under the hood?
I got pulled out of sand in my mustang 10ish years ago, lower rad support bent. I couldnt straighten it. On the cobalt, it is a welded on peice that can be replaced for a large bill. I can look it up if you really need. It is a body shop repair.
I got pulled out of sand in my mustang 10ish years ago, lower rad support bent. I couldnt straighten it. On the cobalt, it is a welded on peice that can be replaced for a large bill. I can look it up if you really need. It is a body shop repair.
Thread
Thread Starter
Forum
Replies
Last Post
DANRICKARD
Problems/Service/Maintenance
8
10-01-2015 12:08 AM