- Cat-Back
- Doh! I can't find it anywhere
- Sweet SS! so..GM Stage kits or Aftermarket?
- Cobalt SS CANNOT be hydrolocked!?
- Ordered Hahn Full Exhaust!
- Bad news??? Victory_red__SS project.
- Urgent !! Please Help !!
- Installed Pacesetter Header to Complete Exhaust
- Stage 2 installed today with the new tune WOW !!!!!!!
- Pacesetter header!!! PICS Turbotec...
- cti owners help
- Which CAI?!!
- hp tuners..
- Just another stupid question needing an answer
- stroker kit???
- Super Charger Noise After Intake Installation
- Where do you weld in a new bung???
- KN filter install help
- GM Stage 2 + 2.8 Pulley
- Brought my stock SS/SC in for 7500 mile service and they did an PCM flash...
- cruise control turned off by cel
- upped rev limit on gm stage2?
- Thank you OniMirage and Cobaltss.net!!
- Installed my Intense trans mounts
- for anyone that has gm stage 2
- for anyone that has gm stage 2
- question about clutch?
- Just installed Vibrant 3''
- What Should We Install?
- Extreme nooblet question
- Tech Data by Dezod Motorsports|| Topic: Collectors
- ECM pinout
- would this work?
- Not getting the results I'd hoped for.
- hurry!!! where to find bwoody traction bars
- Exhaust system
- Are U Serious?
- How many full scan gauges are out there?
- Installed my injen intake and WOW
- Questions about upgrades
- Supercharger Hose(s) part number...
- Throttle position?
- Stage 2 dyno (crappy)
- magnaflow exhaust
- Wich intake?
- What You Thinkl?
- Transmission Stuff (Might wanna stciky the response to this)
- Hahn Full Exhaust Vids I Promised Everyone!
- Rear O2 sensor
- My charger is going gold O_o
- boost guage question...
- 3rd gear vs 4th gear dyno pulls!
- 300whp?
- Wheel Hop causes Clutch Failure
- GMPP exhaust manifold installed
- new clutch install
- Running Lean
- is an idler pulley the only way?
- PSI Question
- Who is selling HPTuner cheap...Plus dont know how to tune
- Probably a noob question...
- Aem Air Bypass Valve
- Just bought Stage 2...
- I need a recipe
- Injen Intake Specs
- any form of boost
- Twin supercharger????
- need some help?? will this setup fit?
- need some help?? will this setup fit?
- Help with tensioner pulley
- Have you had to change belts yet?
- 2.6" and STG 2 BELT
- Too Much Boost?
- What to do questions
- Dilema...
- Pulley Puller...
- cobalt addiction 2.5 DP review
- Im Getting GM Stage 2 Installed Friday!!
- Parts and Warranty
- Just installed the Corsa Touring!
- srt 4 stage 2 turbo
- Trans Fluid Leaks Clutch Slipping And Broken Axles
- How to install the 2.8 pulley on a staged balt
- Stage Kit Prices...look
- I need to know some things about the SS
- Turbo Manifold Info I received and some ?'s
- Ingalls Torque Dampner Owners, Couple Questions
- Tampa Area Pulley Install!!!!
- Just blew a headgasket
- Brake Pad Question..
- Stage kit belt/76mm idler pulley/2.7 pulley...will the belt fit?
- Traction OverKill?
- Who sells hawk HPS brake pads
- AC pressure sensor
- header back choice decision help
- Wheel hop..
- SC Snout Machined
- Exhaust
- 7400 rev limiter???
- HPTuners help, new tune = hesitation (?)
- Crawford Composites Pricing
- HELP!!! Code P0068 and P1183!
- SS Intercooler
- Thinking of buying HPtuners
- blow out valve
- New Toys.
- CEL w/2.9" install and BK7REs
- quick question
- Power @ 8,000 RPM ?
- cti or hahn
- K&N slowed me down
- A little teaser for you guys
- Injen Hydroshield
- Parts
- Finally got a dyno.......
- CA heat exchanger??
- First to blow?
- Question about stage 2 re-flash
- Ingalls Torqyue Damper
- Tuning and 2.6" Installed!!!!!!
- B pipe and O2 sensor... Master Tech Needed
- Intense Racing website?
- Anyway to Eliminate Torque Steering?
- Low Coolant
- Laptop needed for hptuners???
- My Idea...
- Suggestions are welcome for performance.
- Highest Gains with Tune?????
- how to get G85
- going to the track
- the cat
- 2.5" Pulley Questions
- HP tunners question? and prblem.
- Check this out
- running rich with mods.. help
- Pulley Removal
- COBALT Air-to-fuel gauge
- Possible answers? No compression
- For The Love Of God!!!!!!!!!
- Help!!!! Removing the head
- Vaccum at idle...
- Redline short ram intake
- Headgasket and Headstud Ordering & Information For Everyone
- Looking for some info
- aw, freshly recovered recaro for free
- Working on a heat exchanger deal....
- Almost seized the motor!
- Would a Cobalt Tune work on a Redline?
- DYNO and tuning in CHICAGOLAND area
- Cavalier DYNOED!!!!
- GMPP Catback or Aftermarket
- Hahn Racecraft 3"
- Stage II & 2.8 + supporting mods
- My cobalt is gone.
- This is what GM does to us SS/SC guys!
- HP Tuners Question
- Just bought Ingalls Torque Dampner...
- tuning gauges ???
- Throwout Bearing Hose C Clip
- Question about ramps
- Well Well, HeadGasket = Fine Piston = Not Fine
- So my Spec 3+ is Toast.....
- Finally got on a dyno
- Starting mods Safest Way to go
- Does the 03-04 cobra HE work for our car?
- Need part Numbers
- Need part Numbers
- gmpp stage kits???
- Switching Stg 2 Pulley w/ 2.8
- 2.85" pulley for gm stage 2 hub?
- Vendor Help! 2.85" pulley!
- 2.0L supercharger pulley housing sealant
- Is it me or are my rotors screwed?
- Supercharger Measurements
- Some Important Info
- Some Important Info
- best bang for buk mod..
- question about the stock exhaust size
- PB 2.8" install
- aem dry flow filter thoughts...
- Convince me of which CAI to get...
- pistons swap
- PB 2.8" Install Nightmare, Need Help!!!
- sturt bar help
- Motor mounts
- GMPP Touring Exhaust...
- JBP stage 2 cams
- Stock Shift Light???
- Installing Factory heated seat components in a SS/SC, Has Anyone done it?
- stage 2 and 3 clutch from turbo tech the same?
- 2 quickies
- 2.8 pulley installed with gm stage 2
- Next Mod
- anything for 07's
- bumpers
- Intense Stage 4
- So lets talk about my future build.
- unofficial traction thread
- Opinions please
- torque capacity for exedy
- Devils Own Water/Meth Injection
- Lets play guess the dyno number...
- Stock crankshaft pulley size?
- OnStar = Bad idea for tuner?
- pulley question
- I am going to go Super 20G Turbo soon...
- any one with a 07 ss/sc
- Supercharger Mathematics 101!
- mods to beat a STi
- Pacesetter Exhaust
- Stage 2, 2.8 pulley question?
- Stock to 3" pulley Qeastions
- What do u think of this exhaust setup
- intense shorty header and downpipe??
- heat exchanger
- Opcon Autorotor OA 3133 Supercharger
- custom tune
- Maybe a stupid question
- People with corsa or magnaflow exhaust come in here!!!
- What exactly is knock?
- Please help... one more time....
- Need Help Bad!!!
- Gmpp Exhaust Manifold ?dyno?
- which exhaust?
- Limits
- PB 2.8 pulley=me getting no boost and misfire
- Cutouts
- Another next mod topic
- should i
- tune question
- B.o.v
- 2.8 and Plugs
- Boost gauge
- Stock Belt with 3" pulley???
- Slicks?
- Stage 2 first impressions
- where is the cheapest stage 2 belt?
- Boost bypass with Stage 2 and 2.8???????
- smaller pulley with stage 1 tune??
- oil change/ warranty...
- corsa leak....
- cams?
- Before you post in the 2.0 TECH Section, READ THIS!
- Another Twin-Turbo Cobalt SS coming soon!
- new blower.....
- Datalog w/out HPT?
- I think I may have found a source for a Twinscrew!
- 1st time at the track
- Porting..couldnt find much
- Ca Stage 6