- Idle problem CURE!!!!!!!! Finally!!
- Dealer sent me home today with stage 2, but without the tune
- Stage 2 Installation - Rediculous!
- Underdrive/Overdrive/OEM Pulley
- will our injectors work on the 2.2 grand am?
- strange noise at 5k rmp or higher
- how to lower compression ratio?
- 2.6 and 60s?
- Best Heat Exchanger.
- Dex-cool
- whats your 0-60
- Meth Injection Installed - MAF High frequency fail
- Cam gears
- which spark plugs do i need and what is the best??
- Stage 1 worth it?
- Exhaust Question
- FMU + Hand held tuning devices
- little problem... heat exchanger, and meth
- spark plug help
- 0-60 times?
- anybody use jbp intake
- Zzp Pcm
- LED Question.
- stage 2
- just got my spark plugs
- To all the dual exhaust Balts....
- 91 Octane selling for $5.30/Gallon.................oh in Canada....:)
- car runs like crap
- voltage stabilizer?
- So after all the BS my stage 2 kit is finally on
- Help!
- Ordering my stage 2 and getting it put on for $75! Phoenix, Az
- 1st Gen Projectors.
- Cat-back exhaust poll
- Zzp Whisper Resonator Installation as we speek
- Problems with 2.9 Pulley.
- Pulley size?
- Question regarding a Header
- Brakes SSBC? or EBC pads/rotors?
- Air con delete pulley & brk
- Strange exhaust leak or is it?
- gm performance
- 42 lb/hr with dyno tune
- New Super-Low Compression Rods!
- 1st Dyno Run.
- Header Problem
- talk with NGK rep thoughs?
- car is about to get some performance mods but have some questions
- P1183 Supercharger Inlet Pressure Sensor
- replacing my supercharger at 10k miles?
- CX racing HE
- when getting tuned
- CX Racing Mounting Hardware
- cold air intake make the supercharger louder?
- I need help about to make purchase
- About the PCM
- What should I get
- gmpp stage 3 question a/c
- making the vibrant exhaust livable
- help me Cam my LSJ
- Leaky Headlights??
- plug in injectors?
- Fuel Pressure Gauge
- what would be safe
- Tuning Question
- GMMP exhaust sizes
- Dry flow or oil based cold air intake?
- Supercharger Grease! NOT OIL!!
- injectors in a 2.4
- stock header/ installing new one
- 3.5 r.a.w TB
- Tires
- Not sure what to do next...
- buying a downpipe(need help)
- stage two question
- Major Help PLEASE!
- MAF help needed..
- 100% IDC with stage 2? Or my reasonning behind is wrong...
- autolite plug compared to stock
- Turobcharged Cobalts..... Is it true??
- new pcm?
- Launch Control for SS/SC?
- Which downpipe?
- Timing Chain Rattle & Hesitation
- Got a package in today (56k forgeda boutit)
- Boost Question
- wideband options
- is this supercharger ported too much?
- really aggervating
- Need Some Help!
- Need help with part number
- 300WHP build, thoughts?
- 2.8" and 60's safe with STOCK exhaust?
- Ported supercharger?
- How to on Devils Own Meth injection????
- Boost Vacuum Line
- ss/sc help problem!!!!!!
- im out of the game........ :(
- CTI header and downpipe
- Spark Plug Wires?
- installing meth injection in the intake manifold
- Anyone know how to use a tech 2?
- sooo i need some help
- HP tuners
- Help with IDC's w/pics
- Cel P0420
- Few Quick Questions.
- Fuel Pressure Gauge
- Motor mount part number ???
- P1182 & P0068
- Tune on the way
- crank pulley puller
- H/E with turbo..
- Meth Question
- maxing boost gauge with 2.9
- Immediate Help Needed!!
- devils own ???
- rear o2 censor
- enough cooling?
- question
- squeeling from diff
- just got my H/E in
- 2.7 safe?
- Piecing Together Stage 2
- AFCO Heat Exchanger
- stage 2 on its way
- changing my meth setup!
- GM I/C pump
- Found this on ebay
- Line Lock on a ss/sc
- p0300
- 42lb limit
- 2.9 and 60s
- gmpp performance exhaust driving me nuts
- Slight Problem, Help Needed.
- ingalls or weapon R ????
- Meth
- engine hungry?
- Corsa touring or sport?
- 2nd Gear???
- my new full exhaust
- help code p1182 4th time
- Maintenance Day
- Vibrant Stainless Steel Resonator ?
- Your Guys Input
- pulling the pulley
- is anyone zzp twincharged
- H/E help
- NEED some specs..
- NGK Iridium BKR7EIX & 2.9" pulley. What gap would be better? .40 or .35?
- Water Temp Gauge for Manifold Coolant Temp
- zzp combo with megan exhaust
- bwoody cobra he brackets problem
- mass air flow sensor help
- IAT2's
- mother &@!?er
- fuel pressure regulator
- Pulley Question.
- No fun running stright headers!!!!!!
- leaking coolant.....
- bouncing tac at idle stop?
- h/e questions
- Gm Stage 3?
- exhaust question
- gas mileage difference
- Quick Help Please.
- cat or no cat?
- nuts from d/p to catback
- Nate's 2.93 Pulley FTW
- help please....help
- CEL and Codes
- 3" Custom Exhaust w/leaks Clip
- 100 octane
- DEvils own/ engine
- Best cooling mods
- cat/catless question
- Guess my dyno numbers
- Pushing the limits?
- using nates pulley tool
- meth nozzle
- AEM Wideband question?
- downpipe is here!!
- Problem HELP with H/E
- Throwin P0017
- Props to BLILBT!!!
- Which clutch
- Reflashing
- boost gauge acting weird
- getting kinda worried please read
- HP gain?
- FS Brand New Stage 2 kit $470 shipped
- Cat restricting boost?
- Considering 2.79" ZZP pulley. What else do i need??
- ott performance.
- exhaust question
- time for a new block
- Possibly going turbo?
- Throttle Percentage
- who has dc exhaust?
- Timing Chain Tensioner???
- Safe to use a 2.7 pulley without cooling mods?
- Innovate wideband lc-1
- HPT in Denver/Ephrata Area
- Turbo
- High Performance LSJ Cams for Sale
- Magnaflow Exhaust
- ok. so i dont get it. kind of
- Intercooler Help
- why are cobalt addictions stage kits so cheap?
- i want opinions.
- Flywheel hurting me?
- Fuel Pressure Question.
- Oil Catch Can?
- Dyno'd my car today...
- Heat Exchanger.
- just ordered!!!
- should i or what?
- anyone close to buford..... H/E
- Cooling Overkill
- knock retard help????
- Which Meth injection?
- ignition upgrades?
- Couple perfomance part questions...
- Crazy Plan Possible?
- instaling DOWNPIPE
- Intake
- To ZZP Painted Header/DP owners from first GB
- AIS Meth injection kit install complete but Engine Power Recuded problems
- Downpipe is on
- Dumb Question...
- retune after s/c port?
- heat exchangers
- Aeroforce list
- New toys on the way
- I need tech Help....
- Question about Injectors
- Heat Exchanger Help
- full synthetic oils are they the same?
- header/downpipe???
- CA H/E Help
- Cobra Heat Exhanger
- ZZP or GM
- LSJ Potential..
- lossing coolant but no leak
- My order!
- wheel
- psi on 3.0 pulley
- First dyno 266whp
- universal turbo kit only $500
- Throw out Bearing for LSJ Transmission SKU