How do I remove the air vents on the dash of our car?? I was thinking maybe a small screw driver to pop it out but I am not tryin to break anything.

 

The blades you mean? I think the whole vent area is molded in IIRC so you can only take the blades out, not a clue how to do it.

 

I wanted to get the outter trim of the vents off but I was looking and lightly pulling and I think it is molded

 

i think maybe it is molded, but if you figure it out... make sure to make a HOW-to...

 

Mine was molded unless they came up with a really convincing seamless way to attatch it, like hid the seam where it would separate REALLY well.

 

This help?

 

^^^Yep, molded. Cause I think he was talking about that actual trim piece that goes around the vent.

 

I think the exploded view picture makes it look worse than it is...

You have to remove the a-pillars, the trim piece under the windshield, the trim under the dash and around the radio, then the dash cover and some wiring connectors. The guts of the vents are all below the dash cover.

I'm not sure what you're up to but if you need them I have part numbers for the dash cover and the center vent assembly.

 

Yeah but he wants the pieces that look like they go around the vents I believe - I'm guessing to paint them, to take the "vents" out you're really only taking the little blades out.

 

I was going to wrap the outter trim of the airvents with c/f but as the torn apart pic shows its not going to work

 

been wanting to do this myself, almost can gauretee that they are NOT molded in there, they should be snap in piece, that should also be able to snap out...... havent tried it yet, trying to find more info first, dont wanna break one and have GM rape me for a new 1.... If i find more info. will post.

 

they'll come out... just be carefull

 

The surrounds? I cal shenanigans.

 

you've done it? recommend a screw driver or what?