what is the safest way to plug your s/c silencer holes????

 

Rice and glue.

 

plato works pretty good. bubble gum too but not the bazooka brand.

 

Gorilla tape is whats on mine.....

 

I would use a large rubber band with some seamen

 

I used mashed potatoes.

 

at all

 

you know i was gonna recomend that but i heard they would turn to french fries from heat
to OP...quicksteel

 

You guys are all ******* idiots...just give him some serious advice

 

read post above yours
calm down!we are just having some fun

 

There are many threads about this and they all lead to quiksteel being the best.

 

clean it well and use Quicksteel

 

Or I would highly recomend cardboard with some super glue and fiberglass mat

 

duct tape... it says so in the 1001 uses for ductape book i have in front of me

 

QFT!

 

i didnt know such a book existed

 

What are the superchargers made of? are they aluminum? or cast? Has anyone welded them shut yet?

 

what silencer holes?? does this make ur whine louder??

 

well i was just wondering cause right now im using duct tape and news paper but i thought there would be a safer way, thanks guys

 

where are these holes ?!?!?

 

Yes, cast aluminum. No, you can't just weld them, if you warp the blower housing at all, might as well throw it away.

Best bet if you don't want to fill the holes with some type of metal expoy ****, is to have some aluminum plugs made and welded in place. With some small careful stitch welds to hold them, it won't get hot enough to cause damage and it will be much more permanent than any JB weld or Quiksteel bullshit.

 

I want to do it but i have a fear of that **** fallin off. I can tig weld and have a welder but don't want to risk warping it either

 

haha y not just get 2 bolts with big anough washers and tighten them bitchs down and finish off with a nice cold nati lol just throwing the redneck opinion out there

 

I herd peanut butter is good, easy spread to

 

isnt ur sig from that online army game, whats it called???