Best way?

 

A intake will wake it up, as will a ported blower, or running a smaller pulley.

 

intake, porting, plugging the silencer holes, smaller pully,
thats about all you can do to make the whine louder
the intake will make the biggest difference, followed by plugging the silencer holes and porting. A smaller pully will make a small difference as well

 

^then it will be loud as ****

 

dont plug the holes its not worth the consequences.

 

Intake then pulley; if you're still unsatisfied consider plugging the holes, but only if you know what you're doing.

 

^^^
/end of thread.

 

y do some people say plug the holes and others say is bad what can go wrong with plugging the holes

 

What he said.

Please don't plug the damn holes!

 

people use this stuff i think its called quicksteel and the it can fall out of the holes if not done correctly and it will fall into your motor and that will be very bad

 

and a quiet exhaust....

 

dont plug the holes...its not worth it

 

If you do it right there will be no problem. I've had it done for over a year, been in 100+ degree temps and below zero temps. No problem.

It's all in the prep and materials used.

 

anyone thats gotta link to some motor the went kaboom from plugging holes?

 

Intake will be the easiest way...

 

none. if they break up and fall apart, they wont make it past the laminovas
ive never seen someone who plugged their holes post saying it went boom, except someone who used JBWeld way back in the day. quiksteel doesnt really fall out. you gotta really **** up to make em fall out

 

step one: take it apart.

step two: ruin one of the bearings

step three: re-assemble

step four: loud.

 

good point. I feel like every1 is afraid of it when no1 has actually had a problem with it

Did you know if you cross your eyes too long they can stick like that

 

agreed. leave them freakin holes alone. not worth the risk. look at redefined1... he lost one of his plugs and he cant find the damn thing... hes been lucky thus far...

 

^^ thread?
where has he looked so far?

 

yea i saw that ****. its stupid to do it just because it sounds cool. what "advantage" does it actually provide? i would never do it on my car but i guess you guys can do whatever you want to your car. just dont complain when that **** isnt there anymore and you cant find it

 

He probably used the wrong materials and the stuff discintigrated.

Read the eaton blower modification guide, they actuall tell you all about this...

 

small pulley, intake will do the job i have that right now and man it screams. cant wait to get ported

 

bottom line the plugging of the holes is a matter of opinion. i dont believe a damn thing anyone says on here just because everyone thinks they know best. IN MY OPINION the plugging of the holes IS unsafe. done right or not its a risk that dosnt need to be taken... you not gaining **** for performance out of this mod so why do it... just for some sound? BAH!

 

if you want to pay for the intake get it by all means i plan to soon after graduation from college my build starts but cheapest way is to mod the airbox and just slap a K&N filter..look it up under modification forum and ull see step by step i did it in an hour and cost 30 bucks...it sounds close to the stage 2 whine