Can someone please! explain to me how to properly connect and log my AEM wideband wih HP tuners (I have the Pro version HP tuners). I tried the forums on the HP tuners site but it didn't work for me. Any help would be greatly appreciated!

PRess F1 they are the help folders on HPT the info you are looking for is under advanced. Ill try and remember best I can but the white wire goes to your Mpvi pro look in the help files for which pin to hook into youll also need a ground. Ground your gauge and the MPVI ground next to the OBD2 port. Dont forget to enable the PID for the AEM wideband.

I didnt kno you could do that!

The AEM UEGO has a white wire that comes out of the back of the unit. This wire is a 5v output that HPTuners needs. You attach that white wire to on slot on the HPTuners Pro interface and turn on your scanner. While the scanner is open you need to go to your table config and select the EIO input area on the bottom and right click and go to insert. Once in insert you will see a box that will have an aux list availible for you. Click on Wideband 02 to get the box to expand and you will see a bunch of WB's that are availible to select. Click the Wideband 02 - AEM. Now HPTuners is set to record this variable. Now you must input it into an area to record. The graph, histrogram and gauge setup all need to be configured seperatley. For the graph, open it up and go to chart settings and do the same procedure you did to get HPTuners to record it in the first place.

HTH

So let make sure I have this straight! I have to run a ground cable from a particular port on the MPVI unit to somewhere near the OBD2 and the white calbe from the gauge to anywhere on the MPVI unit as well and then set up the proper PID in the scanner software?

can you only do this with HPtuners pro?