i have the gmpp exhaust and headers, im also buying the ca xtc dp. CA give me the price qoute of $200, which i think is pretty good, but i just wanted to get some other price qoutes from others.

im in NJ, bergen county.

i put my full exhaust on by myself. i have no special equipment and used regular tools

i put my full exhaust on by myself. i have no special equipment and used regular tools

ditto

I did my cat back on my own, not difficult at all.

$150 Canadian :) Its worth the drive, get over here. lol jk

i have the gmpp exhaust and headers, im also buying the ca xtc dp. CA give me the price qoute of $200, which i think is pretty good, but i just wanted to get some other price qoutes from others.

im in NJ, bergen county.

by gmpp exhaust and headers you mean exhaust and gmpp exhaust manifold?

did it my self took 30 mins,but dont pay over 50 bucks to have it done

A case of Rickards for Jmacc and about 30 minutes of our time. :)

where in bergen county are you? i'll help you do it...

i paid 25 bucks .. I didnt want to do it in the snow..

i had a whole cat-back made and installed for $350... $200 for installation is a fist in your ass.

i had a whole cat-back made and installed for $350... $200 for installation is a fist in your ass.

X2!!! Same with me, $350 for a full custom 3" mandrel exhaust.

$200 for installation is a fist in your ass.

yeap pretty much...lol.

i had a whole cat-back made and installed for $350... $200 for installation is a fist in your ass.


LMFAO

ima check out the manual tonight, if its easy as every1 says it is ill do it myself

cost me nothing, I did mine myself

LMFAO

ima check out the manual tonight, if its easy as every1 says it is ill do it myself

all you do is unbolt the parts, and bolt the new ones back on... should all be bolt on parts.. get a wrench and some wd-40 and you're good to go

i wish i could get a mandrel bent 3 inch exhaust for 350 that would be AWESOME

I spent 20 to have mine put on. My jack was DOA at the time so I had to have it done.

Later

i wish i could get a mandrel bent 3 inch exhaust for 350 that would be AWESOME

no it wouldn't, 3" is too big

I spent $5 bucks for lift time at the autoshop on base. That's it.

$50-70.00 for reasonable installation cost from shop.

got my sport GMPP done for 52 including the weld on tip .

Who has installed the GMP manifold themselves and is there a how to on this site.

I'm thinking about getting one but was quoted $185 to install from a shop.

i had a 3 inch exhaust bent by tuffy muiffler, i used my own magnaflow muffler, i paid 2 12 packs of mountain dew :) but i know the owners ;)

The cheapest I found out here that will actually do mandrel was about 410 for mandrel cat-back 2.5" with a magnaflow muffler

The cheapest I found out here that will actually do mandrel was about 410 for mandrel cat-back 2.5" with a magnaflow muffler

Is that a CAT-BACK, or full exhaust (manifold back)? If its a cat-back, its a rip, if its full exhaust, then that isn't bad.

i paid 175 to install my headers down pipe exhaust and heat exchanger.