re-installed the meth setup today
re-installed the meth setup today
well today i didn't have any orders to do with the vinyl business so i installed my throttle body plate with tapped in meth injection (cooling mist). I didn't have any HEET at the moment so i haven't tested it out but im sure its going to work perfectly.the nozzle goes into the plate and makes a nice 90 degree bend (tested and it works with washer fluid and compressed air) and has about a 1/4 inch clearance from the butterfly. The black stuff around the fitting is epoxy just to make sure it stays threaded into the plate. I haven't had the meth kit hooked up since last fall when i got tuned so im anxious to see how it does in the 75 degree weather.




Well.....as me and you both found out.....your kit didn't do ****. well it did for like 2 seconds then it drank all the meth lol. Your car is a peice of **** lol. Thats right I said it what now biotch!
he was keeping up with that redline though. About 13's in the slow peice of **** right John? lol
I found my problem was there is supposed to be a checkvalve which isnt supposed to let my meth/water mix through the line when im not under WOT and it had a oring that was leaking which caused meth to be sucked in even at idle. So shes all fixed and runs AWESOME. thanks for helping me last night ORT
haha ORT im going to kill you. I rape stock or near stock SS/SC no problem, i was keeping up with cvenom's stage 2 13.4 second redline on the street though.
I found my problem was there is supposed to be a checkvalve which isnt supposed to let my meth/water mix through the line when im not under WOT and it had a oring that was leaking which caused meth to be sucked in even at idle. So shes all fixed and runs AWESOME. thanks for helping me last night ORT
I found my problem was there is supposed to be a checkvalve which isnt supposed to let my meth/water mix through the line when im not under WOT and it had a oring that was leaking which caused meth to be sucked in even at idle. So shes all fixed and runs AWESOME. thanks for helping me last night ORT
And I didn't really help much, I just got you a wrench and a bowl lol. And John man....what did I tell you about blowing O-Rings out hahaha
Thread
Thread Starter
Forum
Replies
Last Post



