14.9 AFR!! Where is the ECU hookup so I can send narrowband?
Thread Starter
Senior Member
Joined: 03-07-05
Posts: 1,733
Likes: 0
From: San Pedro/PV
14.9 AFR!! Where is the ECU hookup so I can send narrowband?
Shouldn't the LC-1 be reading 14.7? I may have calibrated it incorrectly.
What does your wideband read when the motor isn't running?
I want to use the LC-1 as a narowband but I don't know where the hookup is on the ECU. Pictures would be helpful.
What does your wideband read when the motor isn't running?
I want to use the LC-1 as a narowband but I don't know where the hookup is on the ECU. Pictures would be helpful.
I'm old school
Joined: 02-16-05
Posts: 6,905
Likes: 3
From: Nashville
I should read whatever your engine is actually producing at the time. And when the engine is off, it shouldn't even work since it needs to be hot from the exhaust gases to function correctly.
I have a thread in the tuning section that has pin-outs of various ECM's
https://www.cobaltss.net/forums/tuning-131/ecotec-engine-management-summary-w-pinouts-38412/
I have a thread in the tuning section that has pin-outs of various ECM's
https://www.cobaltss.net/forums/tuning-131/ecotec-engine-management-summary-w-pinouts-38412/
Thread
Thread Starter
Forum
Replies
Last Post