Issue with BADMAB
07-12-2014, 10:20 PM
#1
Issue with BADMAB
Dear BADMAB Industries,
On May 26 2014 I shipped you my header for my 07 Cobalt SS/SC, it arrived at your place of business on June 6 2014. I sent it back for warranty due to numerous cracks around all the welds. As per your warranty claim instructions I enclosed a letter describing what the issue is and even marked all the cracks with a marker.
After it arrived I did not receive any communication from you about it. I have emailed you a few times with only one response which stated " hi mike what was the issue?" (despite the fact I enclosed a letter describing the issues
). It has now been over a month since you received my header and I have heard nothing about what is going on with it, if your repairing it, replacing it, denying the warranty, if its already been shipped, or what.
So whats the scoop? Just give me some communication please!
Thanks
On May 26 2014 I shipped you my header for my 07 Cobalt SS/SC, it arrived at your place of business on June 6 2014. I sent it back for warranty due to numerous cracks around all the welds. As per your warranty claim instructions I enclosed a letter describing what the issue is and even marked all the cracks with a marker.
After it arrived I did not receive any communication from you about it. I have emailed you a few times with only one response which stated " hi mike what was the issue?" (despite the fact I enclosed a letter describing the issues
). It has now been over a month since you received my header and I have heard nothing about what is going on with it, if your repairing it, replacing it, denying the warranty, if its already been shipped, or what. So whats the scoop? Just give me some communication please!
Thanks
07-12-2014, 10:52 PM
#4
good luck. i never received an email back after 2 resent emails about my header being cracked. i was told from brad at badmab that i would have to show proof of purchase. i guess just sending in the header wasnt enough, because i told him i no longer have a receipt and deleted the confirmation email. needless to say, i never got any correspondence back from him and have been rocking a stock header since.
if i wasnt so busy, id just take it to a shop here and get it rewelded, but just havent had time.
if i wasnt so busy, id just take it to a shop here and get it rewelded, but just havent had time.
07-29-2014, 10:30 PM
#12
Senior Member
Join Date: 08-10-08
Location: a
Posts: 5,888
Likes: 0
Received 0 Likes
on
0 Posts
why does everyone look too zzp when it comes to a long tube? seems to me there is better headers then zzp. maybe have a look at the competitors header. I am sure you will be much happier with a ottp product.
at mkripoff
Thread
Thread Starter
Forum
Replies
Last Post