mccullj

iTrader: (2)

ok, so i ordered a glowshift wideband gauge. its the red digital one. it came with directions for it to install. there are 4 wires that are for power. orange, red, white, and black. the directions say the black goes to engine ground, the white goes to a 12v switched power source, and the orange is for dimming. i understand all that and have no issues hooking it up. however, the instructions say nothing about the red wire at all. where does it go? kthx

army_greywolf

iTrader: (2)

to your signal wire on the o2 sensor.

Axelthered05

iTrader: (9)

no its not the signal wire, I had the same problem its your constant power wire just conect it to the battery

BLAZIN07SS

iTrader: (7)

red - 12v constant
white - 12v switched(ex: only has power when ignition is on=sunroof, wipers)
black - ground
orange - dimmer control

this should all be on your installation instructions

Axelthered05

iTrader: (9)

you would think that but aparently glowshift is retarted, I have the same one and it leaves out the red wire in the instructions

mccullj

iTrader: (2)

thanks blazin. that explains it perfect. it wasn't on my instructions. i assumed thats what it was but i didn't want to mess anything up.

i agree. they need to fix that ****.