INTENSE Announces New Dyno Proven Stage Kits!
INTENSE Dyno Proven Stage Kits
Here are the highlights (rated conservatively, of course): Stage 1 = 11 psi boost and up to 235 WHP and 215 WTQ Stage 2 = 13 psi boost and up to 245 WHP and 230 WTQ Stage 3 = 15 psi boost and up to 255 WHP and 245 WTQ Stage 4 = 17 psi boost and up to 265 WHP and 260 WTQ Stage 5 = 19 psi boost and up to 275 WHP and 275 WTQ :D :D :D :D :D |
i was on there earlier and they didnt have them, they must have just put them up. They are sick a hell.
|
does the phase 5 work on 06's? its not listed in the drop down...
|
Very nice. :twothumbs
|
Please note that we're going to hold off a little bit on the '06 Redline PCM's, since we haven't had the opportunity to dyno tune one yet. With the availability of HP Tuners, any vendor can start shipping PCM's immediately, but the right thing to do is invest the time and money for a custom dyno tuning session first. If you have an '06 Redline with stock airbox and want to volunteer for this, please email me at ScottC@INTENSE-Racing.com.
|
Hell of deal!!!!!
|
What are they using to tune the PCM?
|
We use a combination of GM SPS, EASE, HP Tuners and our hand-built electronic P.I.M.P. That stands for PCM Interface Module Prototype.:)
|
Well... IM SELLING EVERY THING I OWN EXCEPT MY CAR!!!!!!!!!!!!! I NEED TO SAVE UP 1000 BUCKS AS QUICKLY AS POSSIBLE!!!!!!!!! ANY DONATIONS ARE WELCOME :lol:
|
n/m i see the 06 now :)
You’ll want to invest in some sort of scan gauge to monitor KR and have a better understanding of everything when you run this much boost. and whats a KR? Will you customize the ECM to our current mods, like intake/exhaust/header?? |
yeah I wanted to know that too. I know what AFR is but not KR?
|
$1,000?!?......SOLD!! I've waited for this (PCM+higher Stage kit) for too long now. Thanks Guys:twothumbs
KR = Knock Retard |
KR is short for Knock Retard. The PCM retards the timing when it detects detonation. Can be very bad and wreck and engine quick if it's bad enough. The knock sensor in the engine block is set up to pick up certain noise frequency in the block that could be knock.
|
How much would it cost for an install by you guys in Plain City, like Intense Stage 5?
|
awesome to think for $1000 bucks i can have a car almost as fast as an evo.
|
so where are the dynos?
|
210$ more for 10hp and 15 torque and 2 pci of boost... I'd go w/ stage 4 if it was me.
|
Yeah I was lookin for some dyno sheets. Also the cars that were tested, were they stock, or did they have other mods (intake, exhaust ect.)?
|
I might be a little off today lol but how exactly do these kits work? Whats in them? I clicked and couldn't figure it out.
|
those are some really kick ass #'s
|
I am looking at the Stage 4 kit, However I already have the Pulleys and the Oversized Tensioner pulley. I don't need the machined snout either. How much would the kit cost without these items?
All I realy need is: Injectors ECU Wiring Harness Plugs What do you use the Supercharger oil for? Just oiling the rotors? or is it used when re-installing the snout? |
Quick calculation came out to approx $410 Can you verify that for me! If you can sell it for that price for just those parts I will cancel my GM Stage 1 order and buy this one.
Also, Does your PCM increase the rev limit at all? |
so the old Stage 3 kit is gone with the wind? dumb question but i assume if i wanted those parts, i could just piece it together, or do you guys not recommend that setup anymore??
just asking, maybe i haven't read enough yet... |
so where are the dynos? How much would the kit cost without these items? I might be a little off today lol but how exactly do these kits work? Whats in them? those are some really kick ass #'s |
so the old Stage 3 kit is gone with the wind? dumb question but i assume if i wanted those parts, i could just piece it together, or do you guys not recommend that setup anymore?? |
All times are GMT -4. The time now is 03:49 PM. |
© 2024 MH Sub I, LLC dba Internet Brands