Blend door actuator replace
Has anyone replaced the HVAC main blend door actuator on 2008 Cobalt SS 2-door?
After the glove box is removed, cabin air filter, should the passenger air bag be de-activated and removed? Is this a dirty job, meaning very difficult? |
They say you have to remove the dash but if you have smaller arms you can reach up through the passenger foot well area and replace it. I have a brand new blend door if you need one.
|
Originally Posted by royce777
(Post 7704164)
They say you have to remove the dash but if you have smaller arms you can reach up through the passenger foot well area and replace it. I have a brand new blend door if you need one.
I'm not 100% positive my condition is blend door actuator. If the A/C system is low on Freon, would low Freon cause the blend door not to function properly? |
Originally Posted by 20171yz67
(Post 7704167)
Thank you for the offer of actuator.
I'm not 100% positive my condition is blend door actuator. If the A/C system is low on Freon, would low Freon cause the blend door not to function properly? |
Originally Posted by royce777
(Post 7704271)
I do not think that has any effect on the blend door. If it is the blend door it will make a clicking noise when switching between different modes. Check out youtube for some videos.
The actuator is not making clicking noise, and the A/C/vent system has been bullet proof from early 2008. If the actuator is not making clicking sound what is the problem?. The Cobalt SS has been like old Buick (Can't kill it) |
Originally Posted by 20171yz67
(Post 7704401)
This is why I'm confused on this repair.
The actuator is not making clicking noise, and the A/C/vent system has been bullet proof from early 2008. If the actuator is not making clicking sound what is the problem?. The Cobalt SS has been like old Buick (Can't kill it) |
This is my problem on 2008 Chevrolet Cobalt 2DR SS
When turning the temperature control to cool receive warm or hot air. I'm unable to bring in outside air or blend warm/cool air into the vehicle. Also A/C air is blocked but compressor is working. |
Originally Posted by 20171yz67
(Post 7705706)
This is my problem on 2008 Chevrolet Cobalt 2DR SS
When turning the temperature control to cool receive warm or hot air. I'm unable to bring in outside air or blend warm/cool air into the vehicle. Also A/C air is blocked but compressor is working. did you replace the blend door actuator? |
The heater vent and air conditioning blend door servo/actuator has not been changed.
Never experienced clicking sound from this servo. I'm I missing something else that could be an easier fix? Do not have problem disengaging air bags and disassembling IP trim if I really need too. |
All times are GMT -4. The time now is 10:40 AM. |
© 2024 MH Sub I, LLC dba Internet Brands