user 72239

iTrader: (4)

If anyone is looking for the bigger O-ring that goes on the outside of the forge unit. This is the part number I got from Ace Hardware that fit perfectly.

kzak104

iTrader: (1)

you can also just actually measure the oring size you need. lol which im pretty sure is what most people do if they do need a new one.

joezombies

I dont have an ace hardware near me. Anyone know where else could have prints large enough to replace the ones on the forge bpv? All of the prints are f***ed on my forge. The one that seals inside the turbo is melted, the ones on the piston are rock hard and don't see well enough for the vacuum to pull it open anymore. Autozone didn't have anything close to big enough.

nutty21

iTrader: (1)

Bump

nutty21

iTrader: (1)

Anyone know anything more about this. See a few threads about this. Seems there is a groove on the opposite side of the connection, that the o-ring doesn't fully seal, so would be nice to have a working part number for a good fit.

user 72239

iTrader: (4)

somehow that picture got deleted. sorry

nutty21

iTrader: (1)

Oh, hey, great youre still here. Do you have and specs for the o-ring? Been sealing good still?

user 72239

iTrader: (4)

I sold that car 2+ years ago. it worked just fine the entire time I ran the gasket. but I dont remember which gasket I bought. You are probably going to have to take it in and match it like I did.

nutty21

iTrader: (1)

Darn, need a second car.fr that, or a lot.of apart, and back together again, and with the LDK, and ZFR, kinda tight and not.fun. ok, cheers