couple balts and a couple hondas
#7
Senior Member
Thread Starter
Join Date: 10-06-05
Location: Seneca, South Carolina
Posts: 10,944
Likes: 0
Received 2 Likes
on
2 Posts
not quite sure, I know he has i/h/e/vtec controller/suspension/maybe cams, a couple other things. He's decently quick for a si. but not much of a match. He gets slaughtered from a roll. lol. He thought he would stand a better chance from a stop, but I beat up on him decently and I was only "***** footing" the launch. lol.
#8
Senior Member
Join Date: 11-23-06
Location: Texas boy stuck in an Iowa Cornfield
Posts: 2,855
Received 0 Likes
on
0 Posts
Nice kills by the way
#9
Senior Member
Thread Starter
Join Date: 10-06-05
Location: Seneca, South Carolina
Posts: 10,944
Likes: 0
Received 2 Likes
on
2 Posts
thanks man, I like that vid too. That was the only vid I didn't really "***** foot" the launch on. And you can tell cause I beat on him pretty badly. lol. all the other vids were launching at like 1500 rpms and just kind of bogging it off the line. lol. I'm loving the DIY mounts as well! no wheel hop at all on any of the runs!
#17
Senior Member
Thread Starter
Join Date: 10-06-05
Location: Seneca, South Carolina
Posts: 10,944
Likes: 0
Received 2 Likes
on
2 Posts
lol. I spit my drink out when I read that. haha. the videos are done my regular camera, and I don't have a tripod. But it is not that hard to take a decent vid. So I'll try to make sure they know what they are doing for now on.
Thread
Thread Starter
Forum
Replies
Last Post
roth
Problems/Service/Maintenance
2
09-26-2015 12:16 PM