Ltbaltbmx 2010 lnf
#1
Senior Member
Thread Starter
Ltbaltbmx 2010 lnf
-AEM CAI
-Injen Charge Pipes
-ZZP Intercooler
-ZZP Engine / Rotated Tranny Mounts
-ZZP Catted Downpipe
-Magnaflow Muffler
-Trifecta tuned
-G85 Package
-TWM Short Throw Shifter
-Megan EZ Street Coilovers
-Injen Charge Pipes
-ZZP Intercooler
-ZZP Engine / Rotated Tranny Mounts
-ZZP Catted Downpipe
-Magnaflow Muffler
-Trifecta tuned
-G85 Package
-TWM Short Throw Shifter
-Megan EZ Street Coilovers
#4
Senior Member
Thread Starter
Maybe its the ricer in me talking but I actually think it looks better without the center caps. I'd give bowtie-less center caps a try if they exist...
#9
Senior Member
Thread Starter
On the current ride height, the tires will rub the fender plastics if I corner just a bit too hard. The car will probably rise by a few more inches. Function over form.
Thank you all for the compliments.
#10
It'll go lower, but not by much. I have it raised because the roads are sketchy around here. The lip has bitten the ground more times than I care to admit to.
On the current ride height, the tires will rub the fender plastics if I corner just a bit too hard. The car will probably rise by a few more inches. Function over form.
Thank you all for the compliments.
On the current ride height, the tires will rub the fender plastics if I corner just a bit too hard. The car will probably rise by a few more inches. Function over form.
Thank you all for the compliments.
#12
Senior Member
iTrader: (1)
The foglight brand is superlight and they're 35w. The tails were a bit tedious to do but doable without special tools. Total cost for me was like $3 because I used component LEDs and had all the tools and caulking on hand. It'll go lower, but not by much. I have it raised because the roads are sketchy around here. The lip has bitten the ground more times than I care to admit to. On the current ride height, the tires will rub the fender plastics if I corner just a bit too hard. The car will probably rise by a few more inches. Function over form. Thank you all for the compliments.
#13
Senior Member
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
DANRICKARD
Problems/Service/Maintenance
8
10-01-2015 12:08 AM