K&N Typhoon got a CEL
10-26-2005, 06:55 PM
#76
New Member
Join Date: 06-21-05
Location: CO
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Installed my Intake on Sunday and here's my experience so far with the CEL light and the K&N intake.
Sunday:
I disconnected the battery for the entire duration of install (about 2hrs)
Reconnected and started the car up and let idle for a couple mins then took it for a drive.
CEL was immediatly on from initial key to run position and starting. I then started and stopped the car 3 different times (had heard the memory reset clears after 3 cycles), but that didn't do anything. Parked the car for the night
Monday:
Had a regular day of work then a some after work fun and then home. All in all it was about 250 miles that day with a total of 3 trips. CEL light was on the whole day. Parked the car over night.
Tuesday:
Started the car CEL was still on, then about halfway to work (15 miles) the CEL goes off and has been off ever since!
I've done another 5 trips and ~100 miles on the car and the CEL is still off.
I'll let everyone know if it comes back on, but as of right now I'm keeping :fingers crossed:
Sunday:
I disconnected the battery for the entire duration of install (about 2hrs)
Reconnected and started the car up and let idle for a couple mins then took it for a drive.
CEL was immediatly on from initial key to run position and starting. I then started and stopped the car 3 different times (had heard the memory reset clears after 3 cycles), but that didn't do anything. Parked the car for the night
Monday:
Had a regular day of work then a some after work fun and then home. All in all it was about 250 miles that day with a total of 3 trips. CEL light was on the whole day. Parked the car over night.
Tuesday:
Started the car CEL was still on, then about halfway to work (15 miles) the CEL goes off and has been off ever since!
I've done another 5 trips and ~100 miles on the car and the CEL is still off.
I'll let everyone know if it comes back on, but as of right now I'm keeping :fingers crossed:
10-29-2005, 03:19 AM
#77
Moderator Alumni
Originally Posted by zinner
Well I just removed my MAF sensor and gave it a liberal shot of CRC a couple times. Let it dry and shot it again. I reinstalled the MAF, I will let everyone know if I get a CEL again. I have been getting them 2-3 times a day all P0171.
Still get the P0171 error all the time
Not sure what else to check.
Thread
Thread Starter
Forum
Replies
Last Post
