Cobalt SS Network - Search Results



Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: cw383
Forum: 2.0L LNF Performance Tech 09-25-2017, 09:29 AM
Replies: 5
Views: 176
Posted By ECaulk
use bank 1 sensors.

use bank 1 sensors.
Forum: Suspension 09-12-2017, 11:14 AM
Replies: 15
Views: 320
Posted By jdbaugh1
From Powell's instructions: Leading arm...

From Powell's instructions:

Leading arm bolts are 50 ft lbs nominal; trailing are 145 ft lbs. Ball joint cross pin
is 37 ft lbs, loosen ¾ turn, 37 ft lbs again +25 degrees.
Forum: Suspension 09-11-2017, 11:24 PM
Replies: 15
Views: 320
Posted By double clutch
Im pretty sure the ball joint for an lsj is...

Im pretty sure the ball joint for an lsj is smaller than an lnf. You could have gotten an lsj ball joint, thus making it a looser fit. Its about 1 mm smaller IIRC
Forum: Suspension 09-11-2017, 08:56 PM
Replies: 15
Views: 320
Posted By 63 Nova SS
You know you could just get new arms from Powell...

You know you could just get new arms from Powell with his cabs already installed. Not cheap I'm sure, but 1 stop shopping.
I screwed up one of my control arms pressing in the cab and just had Powell...
Forum: Suspension 09-11-2017, 06:35 PM
Replies: 15
Views: 320
Posted By jdbaugh1
Pretty sure like 80% that I saw somewhere that...

Pretty sure like 80% that I saw somewhere that FE3 were the same smaller diameter as the FE1.
Forum: Suspension 09-11-2017, 06:28 PM
Replies: 15
Views: 320
Posted By ECaulk
Ask Powell what the specs should look like on the...

Ask Powell what the specs should look like on the control arm bushing for the diameter and then see how close the knuckle is, you should have a mm or two of space between the halfs that collapse...
Forum: 2.0L LNF Performance Tech 09-10-2017, 09:12 PM
Replies: 11
Views: 364
Posted By HGT
Here's a quick 4 minute video that's pretty good...

Here's a quick 4 minute video that's pretty good at showing what I said.

https://www.youtube.com/watch?v=UEmSFDn8Rlw
Forum: 2.0L LNF Performance Tech 09-10-2017, 08:19 PM
Replies: 11
Views: 364
Posted By HGT
I wouldn't increase the gap on a spark tester...

I wouldn't increase the gap on a spark tester until they quit firing rather set it to 40kv and see if they pass. This type of coil was never designed for open circuit firing like coils with plug...
Showing results 1 to 8 of 8

 
Forum Jump

All times are GMT -4. The time now is 05:06 PM.