Cylinder bore
#1
New Member
Thread Starter
Cylinder bore
doing a rebuild an have a bit of vertical scoring my question is if homing won't take care of it can I have the sleeves bored to 86.5 mm ? I can barely feel the scoring with my nail I want to just hone them and slap in some drop in pistons from zzp . What do u guys think ?
#4
Senior Member
Also with a honing tool getting .5mm off wall is possible but boring is better to achieve this the honing tool is more just getting glaze and crosshatching for new rings to set better
#8
New Member
Thread Starter
Gonna see if they can re-sleeve the cylinders . also i can see that the scoring is from detonation probably from pill mod . im gonna have the piston out in about an hour or so can i post pics on here some how ?
Thread
Thread Starter
Forum
Replies
Last Post