Socal dyno day?
Ya, I got the word from him earlier. Good luck in the future.
Heres a vid of someone I tuned not too long ago on the east coast. 2.9, 60s, intake and exhaust, No cooling mods.
Pretty similar pick up, though you may edge him out top end wise. Wait until your beast is dialed in better.
http://www.youtube.com/watch?v=3FLWR-SQUHw&NR=1
Heres a vid of someone I tuned not too long ago on the east coast. 2.9, 60s, intake and exhaust, No cooling mods.
Pretty similar pick up, though you may edge him out top end wise. Wait until your beast is dialed in better.
http://www.youtube.com/watch?v=3FLWR-SQUHw&NR=1
Hahaha, thanks Joey
https://www.cobaltss.net/forums/problems-service-maintenance-69/p2261-bypass-boost-valve-stuck-open-code-195552/
any of u guys know wat this is?
any of u guys know wat this is?
You couldve blown the baffle out from inside the bypass. It will look like its fine on the outside, but the small paper baffle inside may be torn. Needs replacing. Like an 80 dollar part used.
my fueling is 11.6 all the way across, this is just my dd tune for now. just safe basically. i need to install my meth and dual pass now and then i'll work with the fueling table(start rich and lean it out) and probably be able to add another 10* of timing after meth at the top
heres the only one i got...
http://www.youtube.com/watch?v=XcKVVUf60iE
heres the only one i got...
http://www.youtube.com/watch?v=XcKVVUf60iE
you should be blowing the tires off in second gear.
how many lbs/min you flowing?
you need a meth kit? i have ais trunk mount 1.5 gallon with 2 7gph, 1 5gph. i have been thinking of ditching it for race gas.



