Cobalt SS Network - MAF fail high 0Hz causing limp mode

Cobalt SS Network (https://www.cobaltss.net/forums/)

- Tuning (https://www.cobaltss.net/forums/tuning-131/)

- - MAF fail high 0Hz causing limp mode (https://www.cobaltss.net/forums/tuning-131/maf-fail-high-0hz-causing-limp-mode-320747/)

xRedrumisBack

02-21-2016 03:22 PM

MAF fail high 0Hz causing limp mode

Trying to setup my tune to dial in my VE tables and when I set the MAF fail high to 0Hz the car will go into Limp mode almost immediately after I start it, my dash also says "ERROR" after I flash. Any help would be appreciated, thanks!

ItalianJoe1

02-21-2016 03:51 PM

Why would you set it to zero? Set it to 13K or so

xRedrumisBack

02-21-2016 03:56 PM

Quote:

Originally Posted by ItalianJoe1 (Post 7593573)

Why would you set it to zero? Set it to 13K or so

Trying to fail the MAF to tune VE as stated in alot of tuning guides

Slowbalt2000

02-21-2016 04:15 PM

Could unplug it

xRedrumisBack

02-21-2016 04:30 PM

Quote:

Originally Posted by Slowbalt2000 (Post 7593579)

Could unplug it

Seemed to have worked. Have to throttle alittle on startup for the first 15s or it dies but then it runs fine . Thanks!

xRedrumisBack

02-23-2016 12:06 AM

Switched over to vcm suite 3.0 and redid the tunes and scanner and now it works. Haha not sure what changed but tuning is moving forward now.

All times are GMT -4. The time now is 01:53 PM.