I purchased a BC2 body kit and the stock fogs dont fit in the housing. Does anyone know what size i need or where I can purchase them? I was thinking of going yellow and heard that I can get projector fogs is that true?

Also I want to purchase a hood scoop but I dont want it to be functional. At this point its more for show. My concern though is that driving on the highway...with air going in and nowhere to go out that itll rip the tape right off and the scoop will blow away. Does anyone know if this could happen? And odes anyone know a good place to buy them>?

Thanks for your help guys!

 

As for the fogs, the stock fog lights that come on the SS's are projectors...not sure about the LS, LT, or LTZ? And if they don't fit I'm not sure what will, contact the company.

 

If the fogs aren't stock, then I would be iffy about buying them, unless I see what they look like...

 

Block off the port for the scoop, My mom has them on her car and has hard plastic blocking them off.

 

all cobalt factory fogs are projector and its probably gonna be a trial and error on gettin a set that will fit in the bc2 properly.. its most likley gonna be some where in the 2.5-3 inch range on the new fogs that you'll need. you can probably get the size projector lens you need off of ebay..

 

All great advice...I think the cars gonna look great with the fogs and scoop

 

My buddie had a fake scoop on his escourt zx2 held on with 2 bolts or rivits and double sidded tape and i came flying off @ 80 mph on the expressway denting his hood where the rivits were.