Hey guys,

I need two analog signals for wideband output.

One is to hook to HP Tuners and the other is for my wideband gauge.
Is this possible and how?

 

You shouldn't need two.....then again, no clue how you have it hooked up.
which gauge are you using?

 

yes it has two and if you go into the help section of hptuners vcm editor it should tell you all about it

 

Aeroforce interceptor Gauge and I bought a Innovative analog afr gauge which is coming soon. Thus one analog is used (the brown wire / wideband output) the other analog on the LC-1 is Narrow band and can't be changed?

 

Can't your Intereceptor display AFR's?

 

Not Wideband, I don't even think it does Narrowband.
Only way to display wideband on interceptor is to run one of the analog inputs off the interceptor to the wideband output of the LC-1.

 

Not without adding to it.

 

The logworks cd that came with your lc1 has the ability to change the both analogs to whatever you want. just plug the cable into your laptop and open logworks.

 

So you can change the narrowband output to work like a wideband output?

 

very true and very, very simple

I use the xd-16 and hptuners, very simple setup.
I've done one interceptor setup, took about 5 minutes.

I know of a few people that have used the same sensor while loggin wide and narrow band....but not sure about going from narrow to wideband.

 

its just setup as a narrow band now, it can be setup a ton of different ways

 

will read when free