ok guys wht do yaw think about an ott performance heat exchange then a cobra h/e and then the stock h/e? would tht due any good?

 

Go to search on top, and type in heat exchangers, and then select "Search post titles only". Dont forget to click the "2.0 Performance Section" so you get accurate results.

Alot will come up, you can get tons of information from that stuff that pops up.

 

There is no way to fit that, you could run our kit and the stock unit, our unit solo, the cobra unit with stock, or cobra solo.

 

There is also a giant information thread as a sticky on the top of the main thread page.

 

it would be more efficient, but it wont fit.

 

No way to fit it all. On top of that it gets to a point to where your cooling will be inefficient because the proper amount of air is not getting to each heat exchanger. Just do what I did and run the OTTPerformance Heat Exchanger with the stock unit. My IAT2's went from 127* from bottom of 2nd to top of 3rd down to 113* in roughly the same ambient temps.

I've got pics if you want to see them.