so i bought my hid kit of vvme.com for my new projectors and got 9007. after realizing they dont fit at all i did some research and found that i need to return it and get the h1 size. this also means i can only get the low beam kit correct? and also since i have the gen 1 projectors that means i need to buy 4 whole kits for both headlights right?

bump

bump

 

your using stock projectors??? im running 9007 high and low set up on my projectors... ??? was it too long and hitting the little part inside the projector?

at first i was putting it in wrong and found it was touching the inside of the projector, but i put it in right and it worked...

 

You just gonna need two kits. Each kit has a set

??????? You got stock ReFLECTORS or aftermarket PROJECTORS. Cuz 9007 don't fit projectors. U confuse I think

 

1 set=2 bulbs
projectors require 2 sets of bulbs

 

ok so 2 kits i see, thank you

 

Stock headlights use 9007 bulbs. Projectors use different ones not sure which. Stock foglights use H1 bulbs I believe.

 

[QUOTE=Shez;4221879]Stock headlights use 9007 bulbs. Projectors use different ones not sure which. Stock foglights use H1 bulbs I believe.[/QUO

fog is h11

projector is h1...i hope

 

First and third gen projectors use H1 bulbs, second gens use H7. Plus you only really need one kit, which will convert the lowbeams. Putting HIDs in the high beams is useless...

 

Except for the fact that when the lights are on the high beam bulb emits a slight glow that is a non hid color. I have noticed that on my 1st gens.