Not sure if this is the best spot for this message.
When I baught my Cobalt, I traded in my old Dodge Shadow. It needed an O2 Sensor,
and so I still have the new unused O2 Sensor for my shadow? Is it possible/ practical
to do a mod to install it in my Cobalt exhaust system so that it runs ONLY a FUel / Air mixture gauge?
I'm guessing I"ll need to make some sort of Voltage regulor to power it, No problem 1 Amp and below regulators are a sinch to make for 1 - 18 VDC thanks to the LM317 chip.
But since id be useing a Shadow's O2 sensor, im guessing id need a Shadow's gauge? Designed to read off of that sensors...

So where should/ could I put it? The sensor that is?
Or would this not really work so well?
-Jonathan

 

you could but you could also tap into your stock wiring to run an AFR gauge, but to run a WIDEBAND you will need to get a different sensor all together. They are five wire, vs stock o2 sensors are four wire. Some cars come stock with a five wire if you wanted to do it cheap though I am sure you could find an EVO, WRX or some other car that has a five wire and do exactly this.

 

just get a new wideband

 

I did,
I got the Aeroforce Wideband kit hooked to my interceptor.

 

lol why are you necroing all ur post from 09?

 

To celebrate holloween this week.

 

Halloween