ok has anyone ever noticed when doing a scan have you looked at your TPS? on mine all my WOT runs it shows only being at 95% it never goes to 100%. is this a problem i know the 2000+ tansams and cameros had this same problem and there was a fix, but they are not drive by wire. i am just curious if anyone else has noticed this or is it just mine? any help is greatly appreciated

 

I know mine doesn't show over 88%.. but I think it has something to do with hp's calibration... haven' figured out how to fix it yet.

 

The TPS disply has to do with which PID or sensor you use. Which one are you using to get it to show 95%? Wop on Tour said there is one that will show 100% but I cant find it.

 

i never changed any of the PIDS so i figure it is the default one. Have you guys been able to moniter the IAT2? i can't figure that one out either i looked through the PIDS but do not see anything that will show IAT2

 

Do you know how to change your chart settings? IAT2 is Intake Air Temp2 in the PID list. Then you need to click commit changes.

 

You have to get it on the first chart screen... then right click and insert and pull up iat's and what not... thats the only way to get it to read the sensors.,, I think you can display up to 24

 

that is what i had thought but i did not see in there IAT2 i only see the IAT. i added the total knock retard and O2 sensor. i was looking for the IAT2 per chris at HPTUNERS but could not find it

 

Read my post. IT is in the PID list as Intake Air Temp2.

 

IAT2 is all the way near the bottom of the list under engine .... general... and scroll down... it's not near the one for IAT1

 

Camaro....

 

yea yea case of fat fingers

 

ok my bad i am an idiot. i over looked it three times. thanks for the help.

now if we can figure out the TPS we might all be good. i have not checked the actual movement of the throttle plate. i just want to make sure it is opening all the way thats all.

 

cool man... I could't find it at 1st myself... sat and stared at the screen for a while til I actually saw it, if you get that tps thing fixed let me know./.. I've tried like 4-5 of the different settings and so far no luck.

 

SAE TP will show that, using ETC% instead is the fix we all use to show 100%.
You need to add (ETC Position %) on the main table, and swap out all the spots where it's using SAE TPS%.

 

aaah that explains it... thanks man.

 

Hey Daren, what do you mean swap out all spots that are using SAE TPS?

 

Just remove it from the main table, gauge table, line table ect.... So your not logging SAE TPS anymore.