Any cobalt or redline peeps that need their S/C snout machined...
Thread Starter
Senior Member
Joined: 07-06-04
Posts: 2,082
Likes: 2
From: Spaceball 1 or better known as CT
Any cobalt or redline peeps that need their S/C snout machined...
I will be doing this for anyone willing to come down on a Saturday to Norwalk CT.
$50 for the machine work. If you need your s/c removed will help do it on site if you drive down
this is to machine the snout down to accept 2.7 and smaller pullies.
(KEEP in mind that if you have the stock pully on or a GM stage pulley these have to be removed before the machine work is done)
I can remove these(and if you want to put on a new aftermarket pulley) for an additional $25
the machining takes about 30-40 minutes for just the machine work.
Just trying to help out some fellow S/Cers!
$50 for the machine work. If you need your s/c removed will help do it on site if you drive down
this is to machine the snout down to accept 2.7 and smaller pullies.
(KEEP in mind that if you have the stock pully on or a GM stage pulley these have to be removed before the machine work is done)
I can remove these(and if you want to put on a new aftermarket pulley) for an additional $25
the machining takes about 30-40 minutes for just the machine work.
Just trying to help out some fellow S/Cers!
Thread
Thread Starter
Forum
Replies
Last Post
Cptnslo
Complete Cars
9
Sep 24, 2015 09:32 AM
Getaway_Driver
08-10 SS Turbocharged General Discussion
25
Sep 5, 2015 09:16 PM