How do i route my underbody kit wire through the firewall without drilling a hole?



thanks!

 

There is already a hole available. It just has a plug in it from the factory. If Im not mistaken i think it is on the drivers side just underneath the master cylinder but Im not certain

 

Ehh, drill a hole near the back left wheel, and run the wire up straight to the battery. Then just cover up the hole with some poxy

 

I ran mine to my stock fuse box, and my button is right in the middle of my fog lights and dimmer switch. the car must be on, or turned all the way for my neons to be used (so i dont leave them on by accident and run down the battery).

 

there is a hole in the trunk used for somthign I dont remember but there is one there take a look.

 

Theres at least one good hole in the firewall, just look. Theres a LOT of room in these engine compartments.

I might be wirring up some lights this weekend myself...