Look What Showed Up Today!
Look What Showed Up Today!
My lights! Finally they have arrived and look great. Got them from Atomic Street off of eday for 211 shipped(recommended by Gashouse).
Now all is left is to get them in. Any advice would be appreciated!
Now all is left is to get them in. Any advice would be appreciated!
They appear to have bulbs in them besides the turn signal which you just use out of your stockers
Yea the 200 was hard to cough up, but after months I just said I gotta get them
Just found they come w/ turning lights, cools!
Yea the 200 was hard to cough up, but after months I just said I gotta get them
Just found they come w/ turning lights, cools!
Last edited by Beamer; Sep 25, 2007 at 02:49 PM. Reason: Automerged Doublepost
Senior Member
Joined: 03-09-06
Posts: 6,431
Likes: 0
From: Orlando, FL
Mine should be here by the 28th so can't wait to get mine also.
Here are a few how to's to help you out.
https://www.cobaltss.net/forums/show...ght=projectors
https://www.cobaltss.net/forums/show...=projector+aim
Here are a few how to's to help you out.
https://www.cobaltss.net/forums/show...ght=projectors
https://www.cobaltss.net/forums/show...=projector+aim
Senior Member
Joined: 05-19-07
Posts: 625
Likes: 0
From: Cheraw, SC
Projectors were always difficult to get aimed properly for me.. Even using tutorials etc.
I had them in an 04 Mustang I had and replaced them with the factory ones I started with.
Not sure I wanna try that again. It's getting hard enough to see at night without poorly aimed Projectors lol. Older-age is telling on me these days
I had them in an 04 Mustang I had and replaced them with the factory ones I started with.
Not sure I wanna try that again. It's getting hard enough to see at night without poorly aimed Projectors lol. Older-age is telling on me these days
Member
Joined: 05-31-06
Posts: 351
Likes: 0
From: Maryville, TN
It will take you some time to aim them properly. Just take your time and they will come out right. Find a dark road near your house so that you can take them out and test drive them. It will be an on going process, but once you get them right, they will do great.
yea, right now I am just worried about the install. I figured I would get a big board and turn my stocks on, mark where the most light hits(basically like they do are dealers) and go from there. If anything I well take it to the dealer and have them do it since after getting my tires rotated and all the steering pulls to the right slightly which is did not before.
Also, been reading and hearing alot about fogging up inside the light and such. Is there a good way to fix this before I put them in the car? Like just getting sealant and going around the cover and casing.
Also, been reading and hearing alot about fogging up inside the light and such. Is there a good way to fix this before I put them in the car? Like just getting sealant and going around the cover and casing.
Last edited by Beamer; Sep 25, 2007 at 09:57 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post