Can someone tell me how to hook your lc-1 up so that hp tuners will read it>? What do i do with the analog wire that hptuners is suppoose to use . I pluged the wire into the hptuners box but i got nothing im sure i did it wrong but i would really appreciate it if someone give me the steps to take so that i can see my wideband outputs on hptuners thx.

 

Do you have the Pro edition of HPTuners? Did you setup a custom PID for the wideband in the EIO section?

 

The pro edition, and i dont have hpt someone else owns it but we didnt do any of that , please elaborate on what to do . or just tell me what to do from strach please.

 

You're gonna want to check the HPTuners forum. I think they have stickies on how to setup a wideband through the scanner.

Basically you have to configure the software to recognize which input and what type of wideband controller you are using.

 

Been Looking on there for days and i couldnt find anything, hence the reason i came here to ask.

 

Give me a few, I'll find ya something for the LC-1.

Try this:

Under the Help section click "Working with VCM Scanner" then click "Enhanced IO" then "Configuration"

Should contain everything you need.

 

thanks man.

oh another question , the output 2 wire of the lc-1 you just stick it in any of the 4 holes on the hptuners and then do what the link says?

 

I'm honestly not sure, I haven't used an LC-1 with a datalogger before. Most wideband controllers have an analog 0-5v, 0-4v or 1-5v wire used as a signal to the HPT box. That and a ground are the ones you want to use.

 

anyone know how to hook up the wiring?