bent exhaust systems how do i put the joints together do i have to weld it or just slide them into eachother i would like to put it on right now so quick answers would be appriciated THANK YOU. I did search the how to's just so i don't get yelled at to search

 

most of the time they are clamped if its a pre-fab, custom setups will be welded tho

 

Thanks i got it already how did you guys get the stock exhaust out?? That was a pain in the ass and i can't get the 2 mount to stay connected

 

lol. I forgot about that nightmare till you said it. I had to cut the bitch out. Luckily I have access to a lift for all my ****. Me and a friend looked at that for like 15 minutes and cutting it was the only way we saw???

 

yea i had to do that too but all i had was a jack/jackstands and i almost lost my hand cause i used a grinder with a metal cutting wheel on it and it binded and shot back at me but i caught it so i couldn't find any other tool but ended up finding a sawawl and cut that bitch outta there in no time

 

exactly. With all the after market exhausts on this site I would have thought someone would have found something better by now.

 

u cut the stock one off, make one cut ri ght before the torsion beam, than u can pull the stock exhaust off, the MES exhaust piping slides into the next pipe and you clamp them together, although welding is strongly recommended, but not required...thats why clamps are supplied...i recently became a MES vendor, so i havent had the oppotunitty to work on the LNF catback yet, just the other non LNF ones, but they all connect the same