ok guys i've had my ss/sc for a couple of months now n i've beatin some quik cars. i have yet to run it on the track tho! too busy with work n ****. now if u guys read my signiture with all i have done wut do you think my car would run on the track. im in jersey at sealevel and im boosting 15.5 psi? and if i drop down to the 2.7 in pulley with the 42/5 lb injectors and the maf-t wut do u think i'd run then? any info would be greatly appreciated. thanks guys!

 

only one way to find out...but i'd say 14.3-14.6

Kate

 

maybe low 14's mid to high 13's

 

You have almost exactly what I have done, except I have a few more suspension mods. I also have the G85. I would say 13.9-14.2. If you know how to race at the track. If you have never been there before then I say 14.1-14.5 until you learn what you are doing.

I have a 2.8 inch pulley on its way to me now, and my CAB's will be installed tomorrow, so I should have new track times up within the next week or so Ill give you my estimate of you and a 2.7 then

 

yea i kno how to race the track. b4 i got the new job i basicaly lived there. lol now wut r u guys launching at on the tack?

 

I'm leaving around 2500rpm

 

I idle launch, as anything higher and I dont grab :'(

 

xenozx lol love ur quote hahah juggernaut lmfao .... yea traction is an issue .. roll it off the line and go from there haha

 

ya with u on that one...still wish i had that g85..but with what u have and how good of a driver u are and 60fts and all that other ****...giving u the benefit of the doubt i would say 13.7 with a 1.9 60ft and perfect shifting. other then that id say low 14s.

 

I'm going to Jersey this weekend, I'm interested to see if I'll boost the same.

 

My best 60ft was a 2.1 with 35psi in the tires...i tried lauching higher and i tried lower...but it would hop and or spin. the best launch was at 2K with a slip of the clutch till it hook up solid at 3K and then stomped it hard and shifted at 6300 to avoid an accidental fuel cut. Less tire pressure and i am sure i could hit a 2.0...with that you should be able to hit a 14.0 or something close.

 

i wouldnt runa 2.7" on 42.5lb injectors... you should run the 60lbers.