group buy! =p

 

id be interested if these were produced for balts w/ a down pipe/cat.

 

If it were somewhat close to the cost of ZZP's I would be too, Since I do plan on going LT w/3 in catback soonish. E first though!

 

Damn nice looking header!

 

x2 after an actual dyno result. Longtubes here dont seem to have those

 

ever get one of these guys on a balt yet, mike?

 

i guess not =p

 

 

some1 k33ld him?

 

Dont worry, its happened before where he gets way too damn busy and doesnt have time to even turn his computer on much less check his email.

 

Sent a PM about one of these a few days ago.

 

whats the word on the street?

 

Haven't heard anything from him yet.

His last activity was 9/2

 

no1 can txt him =p

 

other bs threads buryin this >_<

 

dude is very very very very very very very very very very hard to get ahold of unless he KNOWS you will be sending him money. Then once he gets the money, he is VERY VERY VERY VERY VERY VERY VERY VERY VERY VERY VERY hard to get ahold of. His phone is usually disconnected more then anything, and he will always have an excuse for why his work is late, or why he took your money and put it towards something else, so has to wait for more money to flow in before he can start your work.

Just saying. This header was supposed to be design and fit on MY CAR! so i know lot about how difficult it is to contact Mike.

 

Good luck selling said product. Dude sounds like a ******* piece of ****.. I don't give a flying dick how ******* busy you are.. I work with a guy who has 3 jobs, works 85 hours a week, and he still is easy to get a hold of and hangs out outside of work.

Shitty customer service = Business down drain. End of story.

 

so zzp or ottp then =p

 

Well, no any good header fabricator could make one for your car thats as good as the amm fab one and better than the zzp/ottp then. And you would likely pay as much as you would have with amm fab.