So my CEL finally came on from my cat being dead from my pig rich GMS2 tune, So I've decided to finally bump up the kit entirely before I replace the cats and such in my exhaust, already have 2.8 pulley, gonna get 60lb injectors and a tune, I was just wondering if it would be safe to drive my car to tampa (Around three hours) untuned on a 2.8 and 60s to get tuned by terminator, or just get dyno tuned locally

 

I wouldn't that could be horrible... just change the parts over when u get there... it should only take like 10 - 15mins..

 

itll run pig rich with 60s on a stage 2 tune. id be afriad of washing the rings/cylinder walls. change them when you get there, they dont take much time to change. the pulley, go ahead and swap it before you leave, just keep it at lower boost levels, or if your foot wont allow it, tie the bypass valve open.

 

you can't run on the 60's but just leave the stg2 injectors in it and take the 60's with you... it only takes a few minutes to change injectors, and don't get into the boost too much with the 2.8 on there until the 60's are on