Hi, i just install to dual pass and after i realized that i Forgot to deplug thé battery and Now everything is hook up right and i dont have any power. I put the key to acc or whatever and nothing happen. Thanks

 

I dont have any power in the fuse box too. I thought that i Forgot to Plug à sensor but i Check again and they are all plug in. What can cause that. I dont know if when i Forgot to displug thé battery made something but i need help. Thanks

 

Ok Now i have power but when it start the rpm goes at 6000 and after the motor turn off. Thank

 

Check the PCM connections if you touched then. Prolly not seated properly

 

That what i think but i Check and everything was fine. Thanks

 

Now i have the p0107 i think it Low voltage on map sensor. I have bad wiring ??

 

Ok i just scan it and he throw and these code:
p0107
p0141. what i have to do to fix this. thanks