WTF why does my car always wheel hop?
 

My car seems to wheel hop everytime in first even when i dont punch it.. any ways to lower this and prevent it even if i get going at a roll and hit it it still does it.. thanks

Maybe bad mounts, check your trans mounts and engine mount.

assuming you have an FE5 car, all sorts of things can affect it - flca bushings, tires/tire pressure, mounts, struts . The best and most economical way to eliminate is to install the original Hardcore stage 1 OTTP mounts. Poly vibrates too much, so a good insert in a rotated mount will do the job. I beleive OTTP sell stage 1 for less than equivalent mounts from other folks on here....try dropping your tire pressures to 22 psi and drive it and tell me if its better. It wont be as good as mounts but it may make the issue less severe. It is caused primarily by axle misalignment ; the M35 trans is not in thesame position as the automatics which delta was designed around....

Take it easy until you get the wheel hop under control - there's been many a crack housing around these forums as a result.

i think it may be time to invest some money in Motor/tranny mounts. or trac bars. i know my LE5 wheel hops all the time too.

assuming you have an FE5 car, all sorts of things can affect it - flca bushings, tires/tire pressure, mounts, struts . The best and most economical way to eliminate is to install the original Hardcore stage 1 OTTP mounts. Poly vibrates too much, so a good insert in a rotated mount will do the job. I beleive OTTP sell stage 1 for less than equivalent mounts from other folks on here....

OTTP /thread

cause you haven't done the jumper mod to unleash the car's 4006whp

selfinfliction are you going for a record of saying 4006 in all your posts? Lol what does that even mean!?

4006 is the answer to everything when someone asks a question before using the search button.

4006whp
4006wtq
4006:1 a/f
4006psi
$4006
4006LB

etc...

I approve.

approved here as well

Dont approve of the 4006 thing.

LMFAO new cod clan tag 4006