Half of an exhaust.. Lol.
Thread Starter
Senior Member
iTrader: (1)
Joined: 05-22-08
Posts: 3,460
Likes: 3
From: New Lenox, Illinois
Half of an exhaust.. Lol.
I'm shipping out my ARK cat-back tomorrow, so I need to throw my stocker back on, problem is, when I took it off, I had torched it (only way to get the stocker off it seems).. See picture below. Besides losing power, lower MPG, and being annoying as ****, am I doing any damage to my car by driving like this for a month or so until my new cat-back comes?
The orange line is where it is torched, at the last 90° when it comes towards to driver side, before it goes over the axle.
The orange line is where it is torched, at the last 90° when it comes towards to driver side, before it goes over the axle.
Thread Starter
Senior Member
iTrader: (1)
Joined: 05-22-08
Posts: 3,460
Likes: 3
From: New Lenox, Illinois
I'm ordering:
CAI 4-1 header (1 5/8" primaries, ceramic coated)
CAI DP (high flow cat, stainless)
CAI cat-back (stainless)
Expensive set-up, but it's quality as hell! And it will be sick!
Thread Starter
Senior Member
iTrader: (1)
Joined: 05-22-08
Posts: 3,460
Likes: 3
From: New Lenox, Illinois
Well, I figure 4 days to transfer $500 I have in PayPal to my bank. Order it Monday, they have to make it, then ship it out.
So I just figure a month, worst case scenario. I'm ordering a header-back, and I want all the **** installed at the same time.
So I just figure a month, worst case scenario. I'm ordering a header-back, and I want all the **** installed at the same time.
yea cool, i just had my 2.5" exhaust installed today with my muffler ITS LOUUUUD to loud i think so im going to put the baffle back in haha. it's fun though. i raced my buddies stock 240sx with a ka24 and beat him twice so that was fun. but nothin to be proud of.
Thread Starter
Senior Member
iTrader: (1)
Joined: 05-22-08
Posts: 3,460
Likes: 3
From: New Lenox, Illinois
What exhaust?
Thread Starter
Senior Member
iTrader: (1)
Joined: 05-22-08
Posts: 3,460
Likes: 3
From: New Lenox, Illinois
Thread Starter
Senior Member
iTrader: (1)
Joined: 05-22-08
Posts: 3,460
Likes: 3
From: New Lenox, Illinois
There IS surface rust on the hangers, it is not bad, I just don't want to damage the finish, and have it not be how you want, so I left it alone. I contacted ARK about it and they said yes, it's very normal, especially during a Chicagoland winter, tons of salt and ****. An SoS pad would take it off no problem though.
I also sent you 6 gaskets. The hardware is also a bit rusty, but ARK said you can replace it with any of the same size hardware, or buy from them if you prefer. If it was me, I would just clean the rust off.. It would be fine.
Like I said though, no dents or anything of that nature. Great condition for being on an entire winter.



