"Knightmare" Build
#80
I know Kenny and Joe the tuner, Joe is a great guy and always has Kennys car running like a champ. I am personally going to use him to tune my car when install my PTE 5558
#82
One more day and it's going down lol. Parts from Hahn are still processing not sure how many more days til it ships but should not be long after the weekend. I'm gonna clean and polish my ttr manifold tomorrow and will post some pics plus make sure my spacer for meth injection fits properly. And clean the bov too.
#89
Senior Member
iTrader: (8)
I think doing it in the dirt/gravel is admirable. You build where you can. I remember being a lot younger (lol) and would work on my car in my moms gravel drive. I was more into car audio and electronics at the time but still had to crawl around to run wires and crap. Just good memories. Great job Bad-A-SS
The following users liked this post:
Bad-A-SS (04-11-2021)
#96
Senior Member
iTrader: (8)
go to big lots, but a 25 dollar angle grinder, go to sears and buy a whole bunch of craftsman 4" cutoff wheels for said angle grinder. Take it to the exhaust. I have used my big lots angle grinder for years and never burned up the motor. Great tool. I think its Cambell Hausfeld, which is actually a great company. The cutoff wheels are quality from sears and they are only a buck or two each.