C6 ZO6 wheels on a cobalt? Can it happen?
#1
Senior Member
Thread Starter
Join Date: 05-11-07
Location: Bourbonnais IL
Posts: 4,741
Likes: 0
Received 0 Likes
on
0 Posts
C6 ZO6 wheels on a cobalt? Can it happen?
Well guys my car is getting lowered at the midwest meet at CED in early April and I am going to pick out my wheels for the car sometime around the end of april. Does anyone know of any website or company that has or could make a set of C6 Z06 wheels for a cobalt. I know the stock Z06 wheels will not even come close to fitting due to their offset and width, I am just looking to see if anyone knows of a place that could make this happen. I think a lot of people would be intrested in this.
#4
Senior Member
Thread Starter
Join Date: 05-11-07
Location: Bourbonnais IL
Posts: 4,741
Likes: 0
Received 0 Likes
on
0 Posts
Damn, I figured it would cost a bit of money but I am not looking to spend 1500$ on just the rims. I could deal with 1000 but thats about all I would be willing to spend. I was thinking maybe there was a company that made replica wheels in different sizes for other cars. Oh well though it was a good idea
#9
Senior Member
Join Date: 12-21-07
Location: lucedale, ms
Posts: 3,741
Likes: 0
Received 0 Likes
on
0 Posts
off set wouldnt be that big a deal if you used the front wheels off the vette.. bolt pattern is diff though.. i believe a vette is a 5x4.75 and the balt is 5x110
#10
Senior Member
Thread Starter
Join Date: 05-11-07
Location: Bourbonnais IL
Posts: 4,741
Likes: 0
Received 0 Likes
on
0 Posts
Yep that is correct. I think even the front wheels would be to wide though for the balt. Can anyone confirm this? I could most likely get the bolt pattern custom drilled.
#18
Senior Member
Thread Starter
Join Date: 05-11-07
Location: Bourbonnais IL
Posts: 4,741
Likes: 0
Received 0 Likes
on
0 Posts
#19
Senior Member
Join Date: 08-23-07
Location: *sighs* NC
Posts: 503
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post