I prefer the look of our cars to,no need for change here,except I want that hood

 

i havent even gotton mine on yet i keep trying to find time to get it done then something comes up. my car is parked now for the winter all this week its going to rain so once
it gets a good day i want to bring it down to the shop and get it put on.

 

bump?

 

Do you have the part number? I looked up what I think is the right part and it was less money than that. Just want do double check.
Dennis

 

i cant remeber the part number i used for it. the dealer should no what part you are looking for its just faster if you tell them the part number. and i havent had it put on yet. im geting it painted but not geting it on till spring time around april befor the big car show near my house starts it will be on

 

I would like to see if it is all possible. I tried to buy one from the dealership near my house but they wanted 294.00 for the part. are you ^%cking kiddin me. I can make one like Mcguyver out of an old paper clip, aluminum foil and nose of a saigon ***** for less than that ****. I have yet too see what a ss/sc lip looks like on a 2.4L. I know the bumper is the same, but craftmanship differs greatly.

 

As an alternative to cutting slots to mount it (not a fun job!) you could cut the tabs off and use urethane adhesive. Some of the aftermarket parts are attatched this way. If you go this route, be careful to not get it on the paint. It'svery hard to clean off.
Dennis