i know that the SS/LTZ front lip has to be on the SS/LTZ front bumper due to the little slots that the tabs on the lip goes into but what if:

you sanded down or got rid of those tabs of the lip kit and put it on your ls/lt bumper the way you would put on the side skirts and rear bumper? like double sided tape and screws/ brackets the way other lip kits would go on

 

While I don't doubt you can do it with screws and double-sided tape, it's so much easier to use the tabs on the lips to secure them to the bumper covers. It's very tedious and time consuming to cut out all the slots, but I think it's worth it in the end. Was for me.

 

only the front has the tabs, so idk to save some money i might consider doing it this way

its fiberglass, correct?

 

no, ABS plastic....

 

so u could still sand down the plastic tabs and put it on the same way as the side skirts and rear