Lazy GM workers
#1
Senior Member
Thread Starter
Join Date: 05-03-06
Location: Orange CA
Posts: 568
Likes: 0
Received 0 Likes
on
0 Posts
Lazy GM workers
I was looking at my car after giving it a wash and realised the the driver side of the front bumper is drooping slightly.
I can almost fit my index finger in between the hood and the head light on the pas side you could bearly fit a credit card between them so im gona tak it to the dealer and have them look at it.
ill post pics later but its a major bummer
Dose anybody els have this prob?
#7
Originally Posted by Gory
I was looking at my car after giving it a wash and realised the the driver side of the front bumper is drooping slightly.
I can almost fit my index finger in between the hood and the head light on the pas side you could bearly fit a credit card between them so im gona tak it to the dealer and have them look at it.
ill post pics later but its a major bummer
Dose anybody els have this prob?
they're pretty much all like that
#15
I doubt it was Johnny factory worker that screwed up your car. If everyone has the problem then it is probably an engineering issue, the workers just make them, give them some credit.
#16
Senior Member
Join Date: 04-24-06
Location: Chester, VA
Posts: 1,948
Likes: 0
Received 0 Likes
on
0 Posts
That was the first thing I saw when I was buying the car. I looked at all the other Cobalts and they were all like that (not quite a finger though). I figured it was engineering problem too.
#18
Senior Member
Thread Starter
Join Date: 05-03-06
Location: Orange CA
Posts: 568
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Tiller
Yep mine does it too. I checked and a lot of base model Cobalts line up perfectly, but the SS front ends seem to have issues.
Post some pics so I can compare it to my car.
Post some pics so I can compare it to my car.
Thread
Thread Starter
Forum
Replies
Last Post
JonyyB
General Cobalt
2
10-05-2004 02:57 AM