i bought some bucket seats off of a buddy and need to find the brackets to install them. i did a search but didnt find much.... i can make my own but would rather buy some but the only ones i see are 200 a pair and 160 a pair!!!!!
before i get flamed for putting racing seats in my car my driver side seat has a bar that digs into my back on the right when making left turns hard... i bought the car used and am pretty sure it was a ratherly large owner before me, and gm says its normal wear and can do nothing about it so i figured id just by the seats my friend had for 125 and only 5 months old...;

 

make your own go buy some T6061 aluminum angle 2 x3 or 3x4 and start drilling /cutting..

 

i think thats the conclusion iv came to were can i buy these materials

 

tractor supply has metal stock if you heve one of those close by. it might be cheaper if you have a welding shop order it though.

 

well my dads a pipefitter and can possibly get some scrap peices im not sure... and he can also weld thats awsome.. when i do this im going to make a how to because there is nothing in the how to forum on how to make them ill do the measurements and all