Z06 Rear Valance
#1
Senior Member
Thread Starter
Join Date: 09-28-06
Location: Columbus, OH - Wilkes Barre, PA
Posts: 2,288
Likes: 0
Received 0 Likes
on
0 Posts
Z06 Rear Valance
As some of you know I have been thinking about doin a custom rear end. The only thing slowing me down is Dimensions! I cant find the dimensions of the Z06 Rear Valance. I dont wanna go to a dealership and get'em but I think that might be the only way.
-------
This is a photoshop I found online and this gave me the idea. *note..I am not moving tails.
-------
This is a photoshop I found online and this gave me the idea. *note..I am not moving tails.
#5
Senior Member
well i can tell you it will be to wide , you may have to cut out the center to shorten it . i think it would look bad ass. i hate the ss/sc rear end it looks ricy to me . was rhinking about just getting a ss/na rear end.
#6
Senior Member
Thread Starter
Join Date: 09-28-06
Location: Columbus, OH - Wilkes Barre, PA
Posts: 2,288
Likes: 0
Received 0 Likes
on
0 Posts
Yea I hate the rear and no kit looks good
The cuttin in the middle would be no problem as long as it doesnt effect the exhaust setup
I am $8000 away from havin her parked. cant wait!!
The cuttin in the middle would be no problem as long as it doesnt effect the exhaust setup
I am $8000 away from havin her parked. cant wait!!
Last edited by 2FST4U; 01-30-2008 at 11:12 AM. Reason: Automerged Doublepost
#15
Senior Member
Join Date: 01-24-06
Location: Warranty Chevrolet, Maryland
Posts: 765
Likes: 0
Received 0 Likes
on
0 Posts
The C6 corvette rear valance is 62 inches at its widest. Now the real problem is its all one piece with the rear bumber. Thats going to cost a pretty penny just to cut up.
#20
Senior Member
Thread Starter
Join Date: 09-28-06
Location: Columbus, OH - Wilkes Barre, PA
Posts: 2,288
Likes: 0
Received 0 Likes
on
0 Posts
I was thinking about that as well
#22
Senior Member
ok, so here's what you do. go buy a 'vette, a zo6. take off all the fenders, but em up, and throw em on your balt. lol
the idea isn't bad but aren't those body pieces gonna cost a LOT?!
the idea isn't bad but aren't those body pieces gonna cost a LOT?!