Canadian Mid East Nunavut, Manitoba, Ontario

Manitoba SS's 2011 Thread!

Old May 24, 2011 | 09:04 AM
  #501  
yellow dragon's Avatar
Thread Starter
Senior Member
iTrader: (1)
 
Joined: 03-01-10
Posts: 3,741
Likes: 7
From: Winnipeg, MB
I didnt I was out drinking but my buddy went over to Kenaston to check out the races and the Cop Chopper was circling overhead and flying overhead up and down Portage, supposedly killed any idea of racing.
Reply
Old May 24, 2011 | 12:29 PM
  #502  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
Originally Posted by yellow dragon
I didnt I was out drinking but my buddy went over to Kenaston to check out the races and the Cop Chopper was circling overhead and flying overhead up and down Portage, supposedly killed any idea of racing.
Haha sounds like my night exactly!!!
Reply
Old May 29, 2011 | 04:09 PM
  #503  
slapbetcommissioner's Avatar
Senior Member
iTrader: (3)
 
Joined: 09-15-09
Posts: 4,140
Likes: 57
From: Winnipeg
What's everyone been up lately?
Reply
Old May 29, 2011 | 06:55 PM
  #504  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
at my cabin.

p.s i need headlights right meow
Reply
Old May 30, 2011 | 12:18 AM
  #505  
slapbetcommissioner's Avatar
Senior Member
iTrader: (3)
 
Joined: 09-15-09
Posts: 4,140
Likes: 57
From: Winnipeg
Ok you can get them tomorrow or this weekend. Just gotta Pickem up.
Reply
Old May 30, 2011 | 11:27 AM
  #506  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
that would be sweet. At least untill i find a set. i can drop off your pod as well.

Now i need to find a way to mount that boost gauge. Brainstorm. Cup holder? air vent? gauge bezel?

Also might need the pillar out of a stock car.
Reply
Old May 30, 2011 | 03:41 PM
  #507  
slapbetcommissioner's Avatar
Senior Member
iTrader: (3)
 
Joined: 09-15-09
Posts: 4,140
Likes: 57
From: Winnipeg
Hmm. Good question.

I think this weekend would be ideal. I got called in to work today.

As for mounting. You should either get a steering wheel mount or fab one up with a stock pillar.
You could just take a pillar out of a base cobalt and buy one of those ones you just screw onto it and drill a hole for the cord.
Was it too big or small fOr the stock boost hole?
Reply
Old Jun 1, 2011 | 02:52 PM
  #508  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
Blue Dustin, i hear you leaving a card with your number and name on peoples cobalts? lol
Reply
Old Jun 1, 2011 | 03:02 PM
  #509  
Bluelightning's Avatar
Got Bewst?
iTrader: (8)
 
Joined: 03-16-10
Posts: 10,948
Likes: 33
From: Winnipeg, Manitoba
Originally Posted by Projekt
Blue Dustin, i hear you leaving a card with your number and name on peoples cobalts? lol
LMAO ya i did this morning when I stopped at Birchwood. Just stuffed my business card in his side window. Figured what the hell. Hes got a nice balt. See if I can get some more Cobalt guys togeather. Buddy of yours I take it?

Last edited by Bluelightning; Jun 1, 2011 at 03:07 PM.
Reply
Old Jun 1, 2011 | 03:31 PM
  #510  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
Originally Posted by Bluelightning
LMAO ya i did this morning when I stopped at Birchwood. Just stuffed my business card in his side window. Figured what the hell. Hes got a nice balt. See if I can get some more Cobalt guys togeather. Buddy of yours I take it?
haha yup. i got a text this afternoon asking whos dustin and does he drive a blue cobalt. lol.

Hes getting tuned for trifecta stage 3 in a few weeks. should be good to see what he can do. I've known him for years. Since i had my last cobalt
Reply
Old Jun 1, 2011 | 03:46 PM
  #511  
Bluelightning's Avatar
Got Bewst?
iTrader: (8)
 
Joined: 03-16-10
Posts: 10,948
Likes: 33
From: Winnipeg, Manitoba
Originally Posted by Projekt
haha yup. i got a text this afternoon asking whos dustin and does he drive a blue cobalt. lol.

Hes getting tuned for trifecta stage 3 in a few weeks. should be good to see what he can do. I've known him for years. Since i had my last cobalt
Lol! That's too funny. How come he's not on here?
Reply
Old Jun 1, 2011 | 03:50 PM
  #512  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
he is. a lot of the older crew abandoned this forum site. Hate to say it but its really gone to the ******* in the last year.
Reply
Old Jun 1, 2011 | 04:03 PM
  #513  
Bluelightning's Avatar
Got Bewst?
iTrader: (8)
 
Joined: 03-16-10
Posts: 10,948
Likes: 33
From: Winnipeg, Manitoba
Originally Posted by Projekt
he is. a lot of the older crew abandoned this forum site. Hate to say it but its really gone to the ******* in the last year.
Probably right around when I joined. Just my luck haha. Well that's too bad. Theres so many Balts in Winnipeg but yet hardly and enthusiasts. It sucks. That's why I left him my business card
Reply
Old Jun 2, 2011 | 11:27 AM
  #514  
Bluelightning's Avatar
Got Bewst?
iTrader: (8)
 
Joined: 03-16-10
Posts: 10,948
Likes: 33
From: Winnipeg, Manitoba
Anyone up for wings sometime? Its finally getting nice out (kinda)
Reply
Old Jun 3, 2011 | 08:58 PM
  #515  
Garret's Avatar
Senior Member
iTrader: (1)
 
Joined: 03-09-09
Posts: 2,259
Likes: 0
From: Winnipeg
I can't believe none of you have run into me yet. Im always out and about
Reply
Old Jun 4, 2011 | 02:35 PM
  #516  
slapbetcommissioner's Avatar
Senior Member
iTrader: (3)
 
Joined: 09-15-09
Posts: 4,140
Likes: 57
From: Winnipeg
I think I've seen you driving. I however wasn't in my Balt. 90% of the time I rock a 92 lumina.
Reply
Old Jun 5, 2011 | 08:37 PM
  #517  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
st3 pretty sure i saw you the other day heading north on route 90
Reply
Old Jun 6, 2011 | 01:23 PM
  #518  
st3's Avatar
st3
New Member
 
Joined: 07-18-08
Posts: 70
Likes: 0
From: Winnipeg, MB
Originally Posted by Projekt
st3 pretty sure i saw you the other day heading north on route 90
Spotted ya as well, looks good!
Reply
Old Jun 6, 2011 | 02:25 PM
  #519  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
haha thanks.

So i am tossing the idea around of hosting a dyno day for Trifecta Winnipeg. I'd front the money and charge a flat rate to do Dyno pulls, Obviously id be offering my tuning services but it would not be required.

If so, Who would be interested in this. Id try to keep a few pulls under 100 dollars. Probably do it towards the start/end of fall. I'll talk to the few dyno shops in town as well as the Heights community.

For my customers this would mean we could dyno before/after the tune to see the progress.

Id like to gauge soem interest on here before i take it "somewhat" public.
Reply
Old Jun 6, 2011 | 04:03 PM
  #520  
Bluelightning's Avatar
Got Bewst?
iTrader: (8)
 
Joined: 03-16-10
Posts: 10,948
Likes: 33
From: Winnipeg, Manitoba
I'm interested. I sent ya a text Jordan. So if hpt makes more hp do I get my money back?
Reply
Old Jun 6, 2011 | 04:11 PM
  #521  
Projekt's Avatar
Senior Member
 
Joined: 06-03-07
Posts: 24,270
Likes: 1
From: Winnipeg, Manitoba, Canada
mmm....no ill reply in a bit just at my desk.
Reply
Old Jun 6, 2011 | 10:03 PM
  #522  
slapbetcommissioner's Avatar
Senior Member
iTrader: (3)
 
Joined: 09-15-09
Posts: 4,140
Likes: 57
From: Winnipeg
Originally Posted by Projekt
haha thanks.

So i am tossing the idea around of hosting a dyno day for Trifecta Winnipeg. I'd front the money and charge a flat rate to do Dyno pulls, Obviously id be offering my tuning services but it would not be required.

If so, Who would be interested in this. Id try to keep a few pulls under 100 dollars. Probably do it towards the start/end of fall. I'll talk to the few dyno shops in town as well as the Heights community.

For my customers this would mean we could dyno before/after the tune to see the progress.

Id like to gauge soem interest on here before i take it "somewhat" public.
I too would be interested. Very interested
Reply
Old Jun 7, 2011 | 10:30 AM
  #523  
yellow dragon's Avatar
Thread Starter
Senior Member
iTrader: (1)
 
Joined: 03-01-10
Posts: 3,741
Likes: 7
From: Winnipeg, MB
Originally Posted by Projekt
haha thanks.

So i am tossing the idea around of hosting a dyno day for Trifecta Winnipeg. I'd front the money and charge a flat rate to do Dyno pulls, Obviously id be offering my tuning services but it would not be required.

If so, Who would be interested in this. Id try to keep a few pulls under 100 dollars. Probably do it towards the start/end of fall. I'll talk to the few dyno shops in town as well as the Heights community.

For my customers this would mean we could dyno before/after the tune to see the progress.

Id like to gauge soem interest on here before i take it "somewhat" public.
Me too provided it's under $100.
Jordan can you PM pricing for Trifecta tune.
Reply
Old Jun 8, 2011 | 01:35 AM
  #524  
Contrastic's Avatar
New Member
 
Joined: 05-23-11
Posts: 94
Likes: 0
From: Canada
*Enters slowly**

Just got my balt a feew weeks back... I'm not too experienced with cars but I really like it. If you see me around I've got a black balt 2006 ss sc. Mostly in the South end
Reply
Old Jun 8, 2011 | 03:44 AM
  #525  
slapbetcommissioner's Avatar
Senior Member
iTrader: (3)
 
Joined: 09-15-09
Posts: 4,140
Likes: 57
From: Winnipeg
Originally Posted by Contrastic
*Enters slowly**

Just got my balt a feew weeks back... I'm not too experienced with cars but I really like it. If you see me around I've got a black balt 2006 ss sc. Mostly in the South end
Welcome! I saw your thread you started. You picked a good Place to start!

Everyone here is pretty friendly if you have any questions!

Not allot of us left here but we are always looking for more people to hang out on track days/wings or new projects. You should post some pics! And add some mods!

Also were you parked on Osborn tonight? There was a black sc parked in the street there. A few around so unlikely but thought I'd ask.

Ps are you stock?
Reply

Thread Tools
Search this Thread

All times are GMT -4. The time now is 04:01 AM.